Toshiba tdp-t100u 用户手册

41

40

■ The default setting menu

This menu shows placement status and other settings.

Set the time to wait for the power to be turned off after the last 
operation is made with no input signal.
Off (not turned off)            30 min.

Set whether the input with signals is only selected or not.

Sets whether to turn on the power when the ON/STANDBY button is pressed 
(Manual), or when the power cord is plugged in (Auto).            Manual             Auto

Sets the lamp power.                                   

Sets the cooling fan speed.

When two or more projectors are used and controlled by the remote 
control respectively, this menu sets the code for the projector and the 
remote control.
[      or      : Enter setting mode]      [           : Select item]      [           : 
Select from 1, 2, 3, 4]      [     :Confirm]      [           :Select OK to end]  
Press [Cancel] to return.

Lock the control panel buttons.
[      or      : Enter setting mode]      [           : Select item]      [           : 
Select On/Off]      [     :Confirm]      [           :Select OK to end]  
Press [Cancel] to return.

Press       . (The password and user logo are not reset.)
Resets all adjustments and settings to their factory settings.

Password function
When [Password] is [On], the Password Setting screen is displayed.

Description

Item

(Rear ceiling)

(Standard)

(Rear)

(Ceiling)

 Low           Standard

Detailed description
[Auto input search]

[On]: Automatically searches the signals that

can be projected, and switches input
from the connected device that outputs
the video signals each time the INPUT
button is pressed. The input from the
connected device that outputs no video
signals is skipped.

[Off]: Displays the Input select menu.

Toggle with 

 

 buttons and press 

button. (The input without signals can be
selected.)

[Power on]

Note that if [Power on] is set to [Auto], then if the power is supplied when restored
after a power outage, the projector will come on.

[Lamp power]

When [Lamp power] is set to [Low], the screen becomes a little darker, but the
cooling fan noise gets quieter.

[Fan mode]

Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan
noise gets louder.) Set this option to use the projector, for example, at high altitude
(over 1,500 meters above sea level).
• Do not set Fan mode to [High] when using the projector at a lower altitude.

[Remote control]

Sets a remote control code from 4 types. You can set each code respectively for up
to 4 projectors. The factory setting is [1].
To switch codes, set the same code for the projector and the remote control.
A remote control code is applied after the setting is done.
• You cannot operate the remote control if the codes of the projector and the

remote control do not match.

Remove the battery cover and set the same remote control code switch as the
projector. 

 (Use a screwdriver with thin tip to set.)

[Key lock]

Protect from operating errors by locking on the control panel buttons of the
projector. (The remote control operations are available.)
Control panel operations are locked after the setting is done, and accordingly
operation with the control panel buttons is disabled.
• To release the key lock, set the [Key Lock] to [Off] using remote control. Pressing

the [RETURN] button on the projector for 10 seconds also sets the [Key Lock] to
[Off]. (In the latter case, the LAMP, TEMP, and FAN indicators light in orange for 3
seconds.)

    /    shows whether signal is 
 input or not.