Toshiba tdp-t250u 业主指南

51

50

Wait for at least 1 hour.

Loosen the two screws, raise the outer lamp
cover with your fingers as shown to remove the
outer lamp cover. Use care to avoid any
damage to nails and/or tip of your finger(s). If
you have any difficulty in removal, you can use
a screwdriver or any other smaller tool for your
convenience.

Loosen the screw to remove the inner lamp
cover.

Loosen the three lamp locking screws, pull up the
handle, and press the tab to remove the lamp.

Align the orientation, press down the new lamp
until the bottom is reached, and lock in place using
the three lamp locking screws.

Outer lamp cover

2

1

1

2

1

2

2

1

Inner lamp cover

Tighten the screw loosened in step 

 until the

inner lamp cover is no longer loose.

Align the cover, and press it in, then tighten the
screws loosened in step 

 until the outer lamp

cover is no longer loose. (Be sure to replace the
outer lamp cover.)

See the lamp’s manual for instructions on resetting
the lamp timer.

• Press the 

 button twice to display (a rough guide) the time of lamp use, the Lamp time

item, in the Status display menu. 

• It is recommended that the lamp be replaced after 2,000 hours of use. When Lamp time

reaches 2,000 hours, the 

 icon and a message will appear with a beep sound. (After

2,000 hours, they will appear when the power is on at the first time every 100 hours.) This
display disappears when you press the 

 button.

• Attach the outer lamp cover correctly so that it is not loose. If it is not attached correctly,

the projector may fail to be powered on or the lamp may fail to come on.

• Always replace the lamp with a new one.
• The lamp is made out of glass. Do not touch the glass surface with your bare hands,

bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)

This projector’s lamps contain trace amounts of environmentally harmful inorganic
mercury. Be careful not to break used lamps, and dispose of them in accordance with
local regulations.

Tab