Toshiba tdp-t98u 业主指南

31

30

■

This menu shows placement status and other settings.

Set the timer to wait for the power to be turned off after signal input stops.
Press      . Switch with       and      .
Off (not turned off)/1 min./5 min./10 min./30 min./60 min.

Set whether the input with signals is only selected or not.

Sets whether to turn on the power when the ON/STANDBY button is pressed 
(Manual), or when the power cord is plugged in (Auto).   Manual             Auto

Sets the lamp power.                                   

Sets the cooling fan speed.

Press       .
Resets all adjustments and settings to their factory settings.

Description

Item

(Rear mounted 
from ceiling)

(Standard)

(Rear)

(Mounted 

from ceiling)

 Low           Standard

Notes
1: When Lamp power is set to Low, the screen becomes a little darker, but the cooling fan noise gets

quieter.

2: Setting [Fan mode] to [High] increases the cooling fan speed.  Set this option to use the projector,

for example, at high altitude (over 1,500 meters above sea level).

• Note that in the event of a power outage but the power is restored afterwards, the projector

power will come on if Power on is set to Auto.

• When you turn off the projector even if Power on is set to Auto, you must press the ON/

STANDBY button to turn the power off.

■

Use this menu to set screen display-related items.

(Full):  Display with 1024 

×

 768 dot resolution

(Thru): Display with sampling resolution (for computer input)
(Wide):  Wide-screen display (for Video, S-video, and Y/P

B

/P

R

)

Select one of the languages below to use for displaying the menu and messages
[     : Enter setting mode]     [          :Selection]      [Apply:       ]
English/Français/Deutsch/Italiano/Español/Português/               /
Svenska/Türkçe/            /                      /                      /

Screen to display when there is no input signal                         (Logo)                            (Blue)                            (Black)

Display icons as function guides

Display start-up screen when power is turned on  On

Description

Item

• If “Thru” is selected for screen size, portions exceeding the native resolution (1024 

×

 768

pixels) will not appear on the screen. Note that for RGB signals with clock frequency
140MHz or lower, all input pixel signals are sampled. However, if the clock speed is
higher than this, the RGB pixel signal is thinned before sampling.