Quantum acl 4 安装指导

Appendix B Supplemental Installation Procedures
Enabling/Disabling the Auto-Load Feature

ACL 4/52 Facilities Planning and Installation Guide

Enabling/Disabling the Auto-Load
Feature

This feature of the ACL 4/52 library enables the operator to load
cartridges into the fixed storage array (FSA) without any intervention
from the host controller. When this feature is

Enabled

, the library will

automatically find bins in the FSA for cartridges that are placed in the
load port. If no bin locations are available in the FSA, the cartridges
will be left in the load port bin and an error message will be displayed
on the control panel SDA.

The default configuration for this feature is Disabled. To enable this
feature on the library, perform the following procedures:

Press and release the Control Panel

STANDBY

button and verify

that the SDA shows

System Off-line

Press and release the

SELECT

button to enter the Menu Mode.

Verify that the following is displayed in the SDA:

Press and release the

SELECT

button to choose the

Configuration

menu.

Verify that the following is displayed in the SDA:

Press the

↓

button six (6) times to bypass the

Inquiry

SCSI

Address

Power-Up State

Num of Drives

Auto Clean

and

Retries

menus. Then verify that the following is displayed in the SDA:

With

Auto Load

displayed on Line #2 of the SDA, press and release

the

SELECT

button and verify that the following is displayed in

the SDA:

Note: “

Disabled” is the default state for the auto-load option. If you want to

change this feature to “Enabled,” proceed to Step 8. Otherwise, exit
the menu mode.

M e n u :

C o n f i g u r a t i o n . .

M e n u : C o n f i g u r a t i

I n q u i r y

M e n u : C o n f i g u r a t i

A u t o L o a d . .

M e n u : A u t o L o a d

D i s a b l e d