KitchenAid kgcd807x 安装指导

4. With the nuts loosened, the blower exhaust scroll can be

easily rotated downward.

5. Retighten each nut with the

³⁄₈" socket, extension and ratchet.

Make Gas Connection

1. Apply pipe-joint compound made for use with Natural and LP

gas to the smaller thread ends of the flexible connector
adapters (see C and G in the following illustration).

2. Attach one adapter to the gas pressure regulator and the

other adapter to the gas shutoff valve. Tighten both adapters.

3. Use a

¹⁵⁄₁₆" combination wrench and channel lock pliers to

attach the flexible connector to the adapters. Check that
connector is not kinked.

Typical flexible connection.

4. Install the pressure regulator with the arrow pointing up

toward the bottom of the cooktop base and in a position
where you can reach the regulator access cap.

IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause
a gas leak. Do not allow the regulator to turn on the pipe
when tightening fittings.

Use only pipe-joint compound made for use with Natural and LP
gas.

Do not use TEFLON

tape. You will need to determine the fittings

required depending on your installation.

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.

Examples of a qualified person include:

licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.

Failure to do so can result in death, explosion, or fire.

A. Manifold entrance
B. Gas pressure regulator

C. Use pipe-joint compound.
D. Adapter (must have ½" male pipe thread)

E. Flexible connector
F. Adapter

G. Use pipe-joint compound.
H. Manual gas shutoff valve

I. ½" or ¾" gas pipe

A. Access cap
B. Rear of cooktop

C. Gas pressure regulator
D. Up arrow. Regulator must be installed with

arrow pointing up to cooktop bottom.