KitchenAid kude50cvss 用户手册

下载
页码 24
8
Very Hard Water
If you have hard water (above 15 grains), clean your filter at least 
once per month. Building up of white residue on your dishwasher 
indicates hard water. For tips on removing spots and stains, see 
“Troubleshooting” section.
Cleaning Instructions
IMPORTANT:  Do not use wire brush, scouring pad, etc. as they 
may damage the filters.
Rinse filter under running water until most soils are removed. If you 
have hard-to-remove soils or calcium deposits from hard water, a 
soft brush may be required.
IMPORTANT: To avoid damage to dishwasher, do not operate your 
dishwasher without the filters properly installed. Be sure the Lower 
Filter is securely in place and the Upper Filter Assembly is locked 
into place. If the Upper Filter Assembly turns freely, it is not locked 
into place.
Dishwasher Care
Cleaning the Dishwasher 
Clean the exterior of the dishwasher with a soft, damp cloth and 
mild detergent. If your dishwasher has a stainless steel exterior, a 
stainless steel cleaner is recommended.
Clean the interior of the dishwasher, with a paste of powdered 
dishwasher detergent and water or use liquid dishwasher detergent 
on a damp sponge to clean the cooled-down interior. 
A white vinegar rinse may remove white spots and film. Vinegar is 
an acid, and using it too often could damage your dishwasher.
Put 2 cups (500 mL) white vinegar in a glass or dishwasher-safe 
measuring cup on the bottom rack. Run the dishwasher through a 
complete washing cycle using an air-dry or an energy-saving dry 
option. Do not use detergent. Vinegar will mix with the wash water.
Storing the Dishwasher 
If you will not be using the dishwasher during the summer months, 
turn off the water and power supply to the dishwasher. In the 
winter, if the dishwasher could be exposed to near freezing 
temperatures or is left in a seasonal dwelling such as a second 
home or vacation home, avoid water damage by having your 
dishwasher winterized by authorized service personnel.
Filter Removal Instructions
1. Turn the Upper Filter 
Assembly ¼ turn 
counterclockwise and lift 
out.
2. Grasp the Lower Filter in 
the circular opening, lift 
slightly, and pull forward to 
remove.
3. Clean the filters as shown 
below.
To remove Upper Filter Assembly
L
O
C
K
UNLOC
K
PUSH DOWN &
TU
R
N
Locating tab
P
U
S
H
D
O
W
N
&
T
U
R
N
L
O
C
K
U
N
L
O
C K
Filter Reinstallation Instructions
1. Noting the previous 
illustrations, place the 
Lower Filter under the 
Locating Tabs in the 
bottom of the dishwasher 
so the round opening for 
the Upper Filter Assembly 
lines up with the round 
opening in the bottom of 
the tub.
To replace Upper Filter Assembly
2. Insert the Upper Filter Assembly into the circular opening in 
the Lower Filter.
3. Slowly rotate the filter clockwise until it drops into place. 
Continue to rotate until the filter is locked into place. If the 
filter is not fully seated (still turns freely), continue to turn 
the filter clockwise until it drops and locks into place. 
NOTE: The Upper Filter Assembly arrow does not have to 
align with the arrow in the Lower Filter as long as the filter is 
locked.
LO
C
K
U
N
LOC
K
PUSH
DO
W
N
&
T
U
R
N
Locating tab
If you have a drain air gap, 
check and clean it if the 
dishwasher isn't draining 
well.