3M scp716w 安装指导

© 3M 2010.  All Rights Reserved. 

3M™ SCP700 Series Mobile Stand 

Assembly and Installation Guide

Prior to moving the SCP700 Series Mobile Stand, the projector arm must be in the stowed position 

(fully retracted). If the arm is not in the stowed position, the projector arm will become unstable and 

possibly hit the wall or the individuals(s) relocating the SCP700 Series Mobile Stand.

Step 5.  Connect the cables to the projector 

according to the Quick Start Guide.

Step 6.  If using the optional accessory I/O module, 

attach the cables as shown in the Quick 

Start Guide.

Step 7.  Power on unit and change image size by 

adjusting the arm extension in or out.

Step 8.  Adjust projector aim by loosening thumb 

screw.

Step 1.  Support the projector arm and push the 

assembly into the stowed position.

Step 2.  When the projector arm is in the full stowed 

position, the safety tab will be in the “up” 

position.

Step 3.  Loop the lanyard and safety pin around the 

mounting knob and drape over the projector 

arm.

Step 4.  Slide the safety pin all the way in through 

the hole that is on the safety tab.

Step 5.  When the safety pin is secured in the safety 

tab, gently release the projector arm.

Repeat these steps, in reverse order, to release the 

projector arm for use.