TROY Group 3005 用户指南

 

 

Security Printing Solutions User’s Guide -- 50-70410-002 Rev. A

 

8-15

 

 

An attempt was made to access a data 
file that the Troy firmware was not 
permitted to access.  This error should not 
occur under normal printer operation 
unless the data files on the printer are 
being simultaneously accessed by a host 
computer via a network file accessing 
connection, such as NFS. 

If the error persists, contact TROY 
Technical Support. 

A firmware update has been uploaded to 
the printer.  This error message may 
appear immediately after the update 
process has been completed, indicating 
that the printer has registered the new 
firmware. 

Re-initialize the printer (cycle printer 
power), or perform a cold reset.  Wait for 
the initialization sequence to finish before 
continuing to use the printer.  The printer 
must be re-initialized in order for the 
firmware update to take effect. 

Your printer detected the presence of a 
second memory card. 

Remove the memory cards one at a time 
until the message is cleared, or contact 
your authorized TROY service 
representative. 

Indicates that the TROY MICR DIMM is 
improperly installed or has failed. 

 

Re-install the TROY DIMM. 

A firmware update has been uploaded to 
the printer.  This error message may 
appear immediately after the update 
process has been completed, indicating 
that the printer has registered the new 
firmware. 

Re-initialize the printer (cycle printer 
power), or perform a cold reset.  Wait for 
the initialization sequence to finish before 
continuing to use the printer.  The printer 
must be re-initialized in order for the 
firmware update to take effect.