TROY Group 3005 用户指南

 

 

 

Security Printing Solutions User’s Guide -- 50-70410-002 Rev. A 

2-10

 

 

 

 
 

 

The user-selectable printer features allow you to customize the operation of your TROY Security Printing 
Solution, adding flexibility, convenience and security.  The TROY Printer Utility is designed to assist the 
administrator with the configuration of the printer’s default MICR and security features (refer to Section 4 – 

 for detailed information).  The TROY Port Monitor is designed to allow 

authorized users access to the printer’s secured resources and to select print job-specific features (refer to Section 
5 – 

 for detailed information).  Before making any changes to the factory default 

printer settings, the administrator should refer to Section 3 – 

 to obtain 

helpful suggestions for setting up and managing your MICR printing system. 
 
 
TROY Security Printing Solutions can be set to one of four pre-defined Printer Types to suit the security 
requirements of your MICR printing environment.  MICR mode must be enabled to allow the printing of MICR 
documents.  If a user attempts to print MICR documents with MICR mode disabled, the documents will print; 
however, an alternate font will be automatically substituted for the MICR font.  The MICR On setting provides 
the least level of security, while the MICR Off with Timeout setting provides the highest level of security for 
MICR printing. 
 
The  Printer Type determines the default MICR mode (either MICR enabled or MICR disabled) for the MICR 
printer.  The default MICR mode is the default state of the TROY Security Printing Solutions printer (either 
MICR enabled or MICR disabled) when the printer is first powered up and/or when the current MICR print job 
has finished (depending on the printer type selected).  Specific commands written into your check-writing 
application will automatically enable and disable MICR mode as needed for your MICR printing environment; 
however, the printer will always automatically reset itself to the pre-defined MICR mode when the printer is first 
powered up or when the current MICR print job has finished.  The table on the next page describes the user-
selectable Printer Types that can be selected using the TROY Printer Utility.