KitchenAid KBSD608EBS 安装指南

1. Measure the distance from point A (as shown) to the back 

wall. Add 

¹⁄₁₆" (1.6 mm) to this measurement to allow the side 

panel to fit into the trim. 

2. If the panel is more than 

¹¹⁄₃₂" (8.7 mm) thick, route the front 

edge to allow the side panel to fit into the trim. 

1. Measure the distance from point A (as shown) to back wall. 

2. Route the front edge of the support board or attach a 

³⁄₈" 

(9.5 mm) board to hold the panel in the cabinet side trim. 

INSTALLATION 

INSTRUCTIONS

Unpack the Refrigerator

■

Do not remove the film covering until the refrigerator is in its 
operating location.

■

All four leveling legs must contact the floor to support and 
stabilize the full weight of the refrigerator.

■

Keep the cardboard shipping piece or plywood under the 
refrigerator until it is installed in the operating location.

1. Remove and save the literature package bag taped to the 

side of the refrigerator and the parts bag behind the grille. 
Remove the four brackets (two on each side) that attach the 
shipping base to the refrigerator bottom. 

NOTE: Do not remove tape and door bracing until the 
refrigerator is in its final location.

2. If necessary, reduce the tipping radius. See “Tipping Radius” 

for ceiling height requirements or “Reduce Tipping Radius” 
for step-by-step instructions. If you do not need to reduce the 
tipping radius, proceed to “Move the Refrigerator into 
House.”