KitchenAid KVIB606DBS 安装指南

8. Secure the lower duct cover to the range hood canopy using 

4 - 4.2 x 8 mm screws.

Complete Installation

1. For non-vented (recirculating) installations only, install 

charcoal filters onto the metal filters. See the “Range Hood 
Care” section.

2. Install metal filters. See the “Range Hood Care” section.

3. Check the operation of the range hood blower and light. See 

the “Range Hood Use” section.

If range hood does not operate, check to see whether a 
circuit breaker has tripped or a household fuse has blown. 

NOTE: To get the most efficient use from your new range hood, 
read the “Range Hood Use” section.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors 
and odors from the cooktop area. For best results, start the hood 
before cooking and allow it to operate several minutes after the 
cooking is complete to clear all smoke and odors from the 
kitchen.

The range hood controls are located on the front side of the 
canopy.

Controls and Features

■

To activate the controls, press and release the desired button.

■

The control feature button will be lit when a control feature is 
turned On.

The range hood automatically enters Sleep Mode when not in 
use. After 10 minutes of no range hood activity, all of the control 
button lights will turn Off. To deactivate Sleep Mode, press any 
button.

Auto Sense allows the range hood fan to turn on automatically 
when it senses heat higher than its allowable temperature limit. 
When Auto Sense is On, the fan speed will increase or decrease 
based on the temperature Auto Sense is measuring.

Auto Sense can be manually increased by pressing a higher fan 
speed. The fan will run at the selected speed for 10 minutes 
before returning to the speed selected for Auto Sense.

If Auto Sense is On, the Auto button light will turn Off and go into 
Sleep Mode when the vent hood is not in use. If the vent hood is 
turned On by the consumer or by Auto Sense, the Auto button 
light will turn On. 

Press AUTO.

NOTE: The range hood is factory-set for the gas cooktop 
mode.

Press and hold AUTO for 5 seconds to switch between the 
gas cooktop and electric cooktop modes.

The Auto button light will flash 5 times when the range hood 
is changed to the electric cooktop mode. Auto Sense is now 
set to work with electric cooktops and ranges.

The Auto button light will flash 3 times when the range hood 
is changed to the gas cooktop mode. Auto Sense is now set 
to work with gas cooktops and ranges.

Changing the cooktop type will change the temperature limit 
for Auto Sense to turn On. When the range hood senses a 
high enough temperature, the fan will start automatically. 
When the temperature drops below the set temperature limit, 
the fan will stop automatically. The Auto button light will turn 
Off after the range hood enters Sleep Mode, but Auto Sense 
is still active.

A

B

C

D

D

E

F

G

H

I