KitchenAid KDRS483VSS 安装指南

6.  Place Natural gas orifice in plastic parts bag for future use 

and keep with package containing literature.
NOTE: There may be extra orifices in your kit.

7.  Replace the burner base.
8.  Replace burner cap.
9.  Repeat steps 2 through 8 for the remaining burners.

1.  Remove grill grate, wave plate, flame spreader, and burner 

assembly. See the “Install Grill Grease Trays” section for 

removal instructions. Set parts aside.

2.  Use a 

1

/

2

" deep-well socket to remove the Natural gas orifice 

hood. Replace with correct grill LP gas orifice hood. See the 

“LP Gas Orifice Spud/Hood Chart.”

3.  Turn LP gas orifice hood down tightly onto orifice base.
4.  Place Natural gas orifice hoods in plastic parts bag for future 

use and keep with package containing literature.

5.  Before replacing the burner assembly, loosen the screw at 

the front of the burner and rotate the shutter so that the 

opening is 

5

/

16

" (8.0 mm) wide.

6.  Reinstall the burner assembly, flame spreader, wave plate, 

and grill grate. See the “Install Grill Grease Trays” section for 

installation instructions.

7.  Open shut-off valve in the gas supply line. The valve is open 

when the handle is parallel to the gas pipe.
REMEMBER: Once you have completed converting the 

grill, test the range for leaks by brushing on an approved 

noncorrosive leak-detection solution. Bubbles will show, 

indicating a leak. Correct any leaks found.

8.  Plug in range or reconnect power.

1.  Refer to the “Make Gas Connection” section for properly 

connecting the range to the gas supply.

2.  Refer to the “Electronic Ignition System” section for proper 

burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the Lo setting for 

each cooktop burner.
Checking for proper cooktop burner flame is very important. 

The small inner cone should have a very distinct blue flame 

1

/

4

" (0.64 cm) to 

1

/

2

" (1.3 cm) long. The outer cone is not 

as distinct as the inner cone. LP gas flames have a slightly 

yellow tip.

3.  Refer to “Complete Installation” in the “Installation 

Instructions” section of this manual to complete this 

procedure.

Natural Gas Conversion

1.  Turn the manual shut-off valve to the closed position.

2.  Unplug range or disconnect power.