KitchenAid KFDD500ESS 尺寸示意图
ELECTRICAL REQUIREMENTS (cont.)
• When a 4-wire, single phase 240 volt, 60 Hz., AC only electrical
supply is available, a 40-amp minimum circuit protection is required
on 30" (76.2 cm) ranges, fused on both sides of the line.
on 30" (76.2 cm) ranges, fused on both sides of the line.
•
The wiring diagram is located on the back of the range or in a clear
plastic bag.
plastic bag.
• A time-delay fuse or circuit breaker is recommended.
CABINET OPENING DIMENSIONS
Cabinet opening dimensions shown are for 25" (64.0 cm) countertop
depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop
height.
height.
IMPORTANT: If installing a range hood or microwave hood combination
above the range, follow range hood or microwave hood combination
installation instructions for dimensional clearances above
the cooktop surface.
installation instructions for dimensional clearances above
the cooktop surface.
Range may be installed with zero clearance to combustible
construction at the rear and on the sides below the cooktop.
A. 18" (45.7 cm) upper cabinet to countertop
B. 13" (33.0 cm) upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to the top of the cooktop, see NOTE.
E. In U.S.A.: 30" (76.2 cm) min. opening width
B. 13" (33.0 cm) upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to the top of the cooktop, see NOTE.
E. In U.S.A.: 30" (76.2 cm) min. opening width
In Canada: 31" (78.7 cm) min. opening width
F. 3" (7.6 cm) min. clearance from both sides of the range
to the side of the wall or other combustible material.
G. Cabinet door or hinges should not extend into the cutout.
H. 3" (7.6 cm) distance from wall
H. 3" (7.6 cm) distance from wall
I. 1
1
/
2
" (3.8 cm) min. from the right side cabinet
J. 8" (20.3 cm) width
K. 7" (17.8 cm) min. from floor
L. 2" (5.1 cm) min. from floor
K. 7" (17.8 cm) min. from floor
L. 2" (5.1 cm) min. from floor
* Drill on centerline 1
1
/
4
" (3.1 cm) from rear wall for gas supply line.
** Gas lines must be installed within the shaded area to ensure proper
alignment of this oven with cabinets.
*** Recessed electrical plugs must be installed within the shaded
area to ensure proper alignment of this oven with cabinets.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet
is covered by not less than 1/4 " (0.64 cm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (.04 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
covered with not less than No. 28 MSG sheet steel, 0.015" (.04 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bttom of an uncovered wood or metal cabinet.
Because Whirlpool Corporation includes a continues commitment to improve our products,
we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details,
see Installation Instructions packed with product. Specifications subject
to change without notice.
to change without notice.
Ref. W10694070B
08/10/15
Page 2 of 2
B
D
C
E
A
F
G
H
I
J
K
L
8½"
(21.6 cm)
14"
(35.6 cm)
8½" (21.6 cm)**
gas line location
1½"
(3.8 cm)
1¼"*
(3.1 cm)
2¼" (5.7 cm)
***
L
• This range is euipped with an UL or CSA International Certified Pwer
Cord intended to be plugged into a standard 14-50R wall receptacle.
Be sure the wall receptacle is within reach of range's final location.
Be sure the wall receptacle is within reach of range's final location.
• Do not use an extension cord.