KitchenAid 30-Inch 5-Burner Dual Fuel Convection Slide-In Range with Baking Drawer 安装指南

7. Repeat steps 1 and 2 to ensure that the range foot is 

engaged in the anti-tip bracket.

If the rear of the range lifts more than ½" (1.3 cm) off the floor 
without resistance, the anti-tip bracket may not be installed 
correctly. Do not operate the range without anti-tip bracket 
installed and engaged. Please reference the “Warranty” 
section of the User Guide to contact service.

8. Move the range into its final location. Check that the range is 

level by placing a level on the oven bottom. See the “Level 
Range” section.

IMPORTANT: If the range is moved to adjust the leveling 
legs, verify that the anti-tip bracket is engaged by repeating 
steps 1 to 8.

Cooktop and oven burners use electronic igniters in place of 
standing pilots. When the cooktop control knob is turned to the 
ignite position, the system creates a spark to light the burner. All 
cooktop burners will spark, but only the burner with the control 
knob turned to the ignite position will produce a flame. This 
sparking continues as long as the control knob is turned to the 
ignite position.

When the oven control is turned to the desired setting, sparking 
occurs and ignites the gas.

Push in and turn each control knob to the ignite position. 

The flame should light within 4 seconds. The first time a burner is 
lit, it may take longer than 4 seconds to light because of air in the 
gas line. 

■

Turn cooktop control knob to the off position. 

■

Check that the range is plugged into a grounded 3 prong 
outlet. Check that the circuit breaker has not tripped or the 
household fuse has not blown. 

■

Check that the gas shutoff valves are set to the open 
position. 

■

Check that burner caps are properly positioned on burner 
bases.

Repeat start-up. If a burner does not light at this point, turn the 
control knobs to the off position and contact your dealer or 
authorized service company for assistance. Please reference the 
“Warranty” section of the User Guide to contact service

If the cooktop “low” burner flame needs to be adjusted for any of 
the burners, see the “Adjust Flame Height” section.

Remove all items from inside the baking drawer, and then allow 
the range to cool completely before attempting to remove the 
drawer.

1. Open the drawer to its fully open position.

2. Using a flat-blade screwdriver, gently loosen the drawer from 

the glide alignment notch, and then lift up the drawer 
alignment tab from the glide.

3. Repeat Step 2 on the other side. The drawer is no longer 

attached to the drawer glides. Using both hands, pick up the 
drawer to complete the removal.

1. Align the forward drawer notches with the notches in the 

drawer glides on both sides. Place the rear alignment tabs 
into the drawer glides on both sides.

2. Push the drawer in all the way.

3. Gently open and close the drawer to ensure it is seated 

properly on the glides on both sides.

A

B

C

A

B