KitchenAid KVWB400DSS 安装指南

Make Electrical Connection

1.  Disconnect power.
2.  Remove terminal box cover.
3.  Remove the knockout in the terminal box and install a UL 

Listed or CSA Approved 

1

/

2

" strain relief.

4.  Run home power supply wiring through 

1

/

2

" strain relief into 

terminal box.

5.  Use UL Listed wire connectors and connect white wires (B) 

together.

6.  Use UL Listed wire connectors and connect black wires (C) 

together.

7.  Connect green (or bare) ground wire from home power 

supply to the 2 yellow-green ground wires (D) in terminal box 

using UL Listed wire connectors.

8.  Tighten strain relief screw.
9.  Install terminal box cover.
10. Reconnect power.

For optional power cord kit installations, follow the instructions 

supplied with the power cord kit. See the “Assistance or 

Service” section for information on ordering.
NOTE: Use only with range hood cord connection kits that have 

been investigated and found acceptable for use with this model 

range hood.

Install Vent Covers

1.  When using both upper and lower vent covers, push lower 

cover down onto hood and lift upper cover to ceiling and 

install with (2) 2.9 x 6.5 mm screws.
NOTE: For vented installations, the upper vent cover may be 

reversed to hide slots.

Complete Installation

1.  For non-vented (recirculating) installations only, install 

charcoal filters over grille on blower housing. See the “Range 

Hood Care” section.

2.  Install metal filters. See the “Range Hood Care” section.
3.  Check the operation of the range hood blower and light. See 

the “Range Hood Use” section.

NOTE: To get the most efficient use from your new range hood, 

read the “Range Hood Use” section.