Netgear M4300-52G (GSM4352S) - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 软件指南
Switching Commands
607
M4200 and M4300 Series ProSAFE Managed Switches
auto-dos
This command enables Auto-DoS on the switch. By default, Auto-Dos is disabled.
When you enable Auto-DoS, all denial of service (DoS) checks are activated. If the switch
detects a DoS attack, the offending packets are copied to the CPU and Auto-DoS shuts down
the port and moves the port to the diagnostically disabled state. To use the port again, you
must manually reenable the port.
detects a DoS attack, the offending packets are copied to the CPU and Auto-DoS shuts down
the port and moves the port to the diagnostically disabled state. To use the port again, you
must manually reenable the port.
no auto-dos
This command disables Auto-DoS on the switch.
show auto-dos
The output of this command shows whether Auto-DoS is enabled on the switch.
MAC Database Commands
This section describes the commands you use to configure and view information about the
MAC databases.
MAC databases.
bridge aging-time
This command configures the forwarding database address aging time-out in seconds. The
seconds
seconds
parameter must be within the range of 10 to 1,000,000 seconds. In an SVL
system, the [fdbid/all] parameter is not used and will be ignored if entered. In an SVL system,
the [fdbid/all] parameter is not used and will be ignored if entered.
the [fdbid/all] parameter is not used and will be ignored if entered.
Format
auto-dos
Mode
Global Config
Format
no auto-dos
Mode
Global Config
Format
show auto-dos
Mode
Global Config
Default
300
Format
bridge aging-time seconds
Mode
Global Config