Netgear M4300-52G (GSM4352S) - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 软件指南

The commands in this section describe how to create, delete, and manage tunnel 
interfaces.Several different types of tunnels provide functionality to facilitate the transition of 
IPv4 networks to IPv6 networks. These tunnels are divided into two classes: configured and 
automatic. The distinction is that configured tunnels are explicitly configured with a 
destination or endpoint of the tunnel. Automatic tunnels, in contrast, infer the endpoint of the 
tunnel from the destination address of packets routed into the tunnel. To assign an IP 
address to the tunnel interface, see 

on page 633. To assign an IPv6 address to 

the tunnel interface, see 

Use this command to enter the Interface Config mode for a tunnel interface. The 

 

range is 

0 to 7.

This command removes the tunnel interface and associated configuration parameters for the 
specified tunnel interface.

This command specifies the source transport address of the tunnel, either explicitly or by 
reference to an interface.

This command specifies the destination transport address of the tunnel.

Format

interface tunnel tunnel-id

Mode

Global Config

Format

no interface tunnel tunnel-id

Mode

Global Config

Format

tunnel source {ipv4-address | ethernet unit/slot/port}

Mode

Interface Config

Format

tunnel destination ipv4-address

Mode

Interface Config