Netgear M4300-52G (GSM4352S) - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 软件指南

This command sets the OSPF area to which the specified router interface or range of 
interfaces belongs. It also enables OSPF on the specified router interface or range of 
interfaces. The area-id is a 32-bit integer, formatted as a 4-digit dotted-decimal number or 
a decimal value in the range of 0-4294967295. The area-id uniquely identifies the area to 
which the interface connects. Assigning an area ID for an area that does not yet exist, causes 
the area to be created with default values.

This command configures the cost on an OSPF interface or range of interfaces. The cost 
parameter has is in the range of 1 to 65535.

This command configures the default cost on an OSPF interface.

Format

no trapflags {all | errors {all | authentication-failure | bad-packet | 

config-error | virt-authentication-failure | virt-bad-packet | 

virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all | 

lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets | 

virt-packets} | state-change {all | if-state-change | neighbor-state-change | 

virtif-state-change | virtneighbor-state-change}}

Mode

Router OSPFv3 Config

Format

ipv6 ospf area area-id

Mode

Interface Config

Default

10

Format

ipv6 ospf cost cost

Mode

Interface Config

Format

no ipv6 ospf cost

Mode

Interface Config