Netgear M4300-52G (GSM4352S) - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 软件指南

This command deletes a periodic time entry from a time range.

Use this command to display a time range and all the absolute/periodic time entries that are 
defined for the time range. Use the name parameter to identify a specific time range to 
display. When name is not specified, all the time ranges defined in the system are displayed.

The information in the following table displays when no time range name is specified.

This section describes the commands you use to configure Auto-Voice over IP (VoIP) 
commands. The Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and 
provides them with a better class-of-service than ordinary traffic. When you enable the 

Auto-VoIP feature on an interface, the interface scans incoming traffic for the following 

call-control protocols:

Session Initiation Protocol (SIP)

H.323

Skinny Client Control Protocol (SCCP)

When a call-control protocol is detected, the switch assigns the traffic in that session to the 
highest CoS queue, which is generally used for time-sensitive traffic.

Format

no periodic days-of-the-week time to time

Mode

Time-Range Config 

Format

show time-range [name]

Mode

Privileged EXEC

Admin Mode

The administrative mode of the time range feature on the switch

Current number of all Time 
Ranges

The number of time ranges currently configured in the system.

Maximum number of all Time 
Ranges

The maximum number of time ranges that can be configured in the system.

Time Range Name

Name of the time range.

Status

Status of the time range (active/inactive)

Periodic Entry count

The number of periodic entries configured for the time range.

Absolute Entry

Indicates whether an absolute entry has been configured for the time range (Exists).