Netgear GSM7328Sv2 - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch 管理员指南
106
|
Chapter 9. VRRP
ProSafe 7000 Managed Switch Release 8.0.3
VRRP on a Master Router
This example shows how to configure the 7000 Series Managed Switch to support VRRP.
Router 1 is the default master router for the virtual route, and Router 2 is the backup router.
Router 1 is the default master router for the virtual route, and Router 2 is the backup router.
CLI: Configure VRRP on a Master Router
1.
Enable routing for the switch. IP forwarding will then be enabled by default.
2.
Configure the IP addresses and subnet masks for the port that will participate in the protocol.
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.0.0
(Netgear Switch) (Interface 1/0/2)#exit
3.
Enable VRRP for the switch.
(Netgear Switch) (Config)#ip vrrp
4.
Assign virtual router IDs to port that will participate in the protocol.
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20
5.
Specify the IP address that the virtual router function will recognize. Note that the virtual IP
address on port 1/0/2 is the same as the port’s actual IP address therefore, this router will
always be the VRRP master when it is active. The default priority is 255.
address on port 1/0/2 is the same as the port’s actual IP address therefore, this router will
always be the VRRP master when it is active. The default priority is 255.
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20 ip 192.150.2.1
6.
Enable VRRP on the port.
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20 mode
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#ip routing