Netgear GSM7328Sv2 - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch 管理员指南
230
|
Chapter 14. Security Management
ProSafe 7000 Managed Switch Release 8.0.3
Create a Static Address
The example is shown as CLI commands and as a Web interface procedure.
CLI: Create a Static Address
(Netgear Switch) (Interface 1/0/1)#port-security mac-address 00:13:00:01:02:03
Web Interface: Create a Static Address
1.
Select Security > Traffic Control > Port Security > Static MAC address. A screen
similar to the following displays.
similar to the following displays.
2.
Under Port List, in the Interface list, select 1/0/1.
3.
In the Static MAC Address section of the screen, enter the following information:
•
In the Static MAC Address field, enter 00:13:00:01:02:03.
•
In the Vlan ID list, select 3.
4.
Click Add.
Protected Ports
This section describes how to set up protected ports on the switch. Some situations might
require that traffic is prevented from being forwarded between any ports at Layer 2 so that
one user cannot see the traffic of another user on the same switch. Protected ports can:
require that traffic is prevented from being forwarded between any ports at Layer 2 so that
one user cannot see the traffic of another user on the same switch. Protected ports can:
•
Prevent traffic from being forwarded between protected ports.
•
Allow traffic to be forwarded between a protected port and a non-protected port.