KitchenAid 5-Burner Gas Freestanding Double Oven Range, Architect® Series II 安装指南

6.  Position the broil burner against the roof of the oven cavity 

and attach with screw.

1.  If the burner grates are installed, remove them.
2.  Remove the burner caps.
3.  Using a Phillips or TORX

®

 screwdriver, remove the burner 

base.

4.  Apply masking tape to the end of a 

9

/

32

" (7.0 mm) nut driver 

to help hold the Natural gas orifice spud in the nut driver 

while changing it. Press nut driver down onto the Natural gas 

orifice spud and remove by turning it counterclockwise and 

lifting out. Set the Natural gas orifice spud aside.

Use the following chart for correct LP gas orifice spud for each 

burner. Refer to the model/serial/rating plate behind the control 

panel for proper sizing of LP gas orifice spuds for each burner 

location.

4,000 BTU

Blue

64L

7,000 BTU

Black

81L

9,100 BTU

Green

97L

14,000 BTU

Red

114L

5.  Replace the Natural gas orifice spud with the correct LP gas 

orifice spud. See the “LP Gas Orifice Spud Chart.”

6.  Replace burner base and hand tighten the screws.
7.  Replace burner cap.
8.  Repeat steps 1 through 7 for the remaining burners.
9.  Place Natural gas orifice spuds in plastic parts bag for future 

use and keep with literature package.

10. Replace burner grates.
11. Complete installation. See the “Make Gas Connection” and 

“Electronic Ignition System” sections.
Checking for proper cooktop burner flame is very important. 

The small inner cone should have a very distinct blue flame 

1

/

4

" to 

1

/

2

" long. The outer cone is not as distinct as the inner 

cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the LO setting for each 

cooktop burner. See “Adjust Flame Height” in the “Electronic 

Ignition System” section.

1.  Turn manual shut-off valve to the closed position.

2.  Unplug range or disconnect power.