KitchenAid 5-Burner Gas Freestanding Double Oven Range, Architect® Series II 安装指南

4.  Gas supply pipe must be located within the shaded area as 

shown in the “Cabinet Dimensions” illustration in “Location 

Requirements” section.

1.  Open the manual shut-off valve in the gas supply line. The 

valve is open when the handle is parallel to the gas pipe.

2.  Test all connections by brushing on an approved 

noncorrosive leak-detection solution. If bubbles appear, a 

leak is indicated. Correct any leak found.

3.  Remove cooktop burner caps and grates from parts 

package. Align recess in burner caps with pins in burner 

base. Burner caps should be level when properly positioned. 

If burner caps are not properly positioned, surface burners 

will not light. Place burner grates over burners and caps.

4.  Plug into a grounded 3 prong outlet. 

1.  Place the outside of your foot against the bottom front of 

the oven door to keep the range from moving, and grasp the 

lower right or left side of the control panel as shown.
NOTE: If your countertop is mounted with a backsplash, it 

may be necessary to grasp the range higher than is shown in 

the illustration.

2.  Slowly attempt to tilt the range forward.

If you encounter immediate resistance, the range foot is 

engaged in the anti-tip bracket.

3.  If the rear of the range lifts more than 

1

/

2

" (1.3 cm) off the 

floor without resistance, stop tilting the range and lower it 

gently back to the floor. The range foot is not engaged in the 

anti-tip bracket.

IMPORTANT: If there is a snapping or popping sound when 

lifting the range, the range may not be fully engaged in the 

bracket. Check to see if there are obstructions keeping the range 

from sliding to the wall or keeping the range foot from sliding 

into the bracket. Verify that the bracket is held securely in place 

by the mounting screws.
4.  Slide the range forward and verify that the anti-tip bracket is 

securely attached to the floor or wall.

5.  Slide range back so the rear range foot is inserted into the 

slot of the anti-tip bracket.

IMPORTANT: If the back of the range is more than 2" (5.1 cm) 

from the mounting wall, the rear range foot may not engage 

the bracket. Slide the range forward and determine if there 

is an obstruction between the range and the mounting wall. 

If you need assistance or service, refer to the “Assistance or 

Service” section of the Use and Care Guide, or the cover or 

the “Warranty” section of the User Instructions, for contact 

information.
6.  Repeat steps 1 and 2 to ensure that the range foot is 

engaged in the anti-tip bracket.
If the rear of the range lifts more than 

1

/

2

" (1.3 cm) off 

the floor without resistance, the anti-tip bracket may not 

be installed correctly. Do not operate the range without 

anti-tip bracket installed and engaged. Please reference 

the “Assistance or Service” section of the Use and Care 

Guide, or the cover or the “Warranty” section of the User 

Instructions, to contact service.