KitchenAid 20.4 cu. ft. 36" Width Right-Hand Door Swing 安装指南

1. Loosen, but do not remove, the four Torx

®†

 27 flat-head 

mounting screws and the two 

¹⁄₄" hex-head mounting screws 

in the top hinge.

2. Adjust the top hinge of the door to align it.
3. Tighten the Torx

®†

 27 flat-head mounting screws to a torque of 

approximately 100 inch-pounds (11.3 Nm).

4. Tighten the 

¹⁄₄" hex-head screws.

If the built-in area depth is 25" (63.5 cm) or more, the side panels 
can be installed inside the side trim or attached to the outside of 
the side trim.
IMPORTANT: KitchenAid is not responsible for the removal or 
addition of molding or decorative panels that would not allow 
access to the refrigerator for service.
1. For the inside side trim piece, slide the front edge of the 

routed side panel into the trim piece.

2. Nail the rear edge of the panel to the support board. 

There are two pieces to the base grille to allow for a custom fit: the 
base grille itself and the skirt. The skirt can be added to the base 
grille in order to extend it all the way to the floor.

1. To see if the skirt is needed, place the base grille into position. 

Do not attach the base grille to the refrigerator. Measure the 
distance between the bottom of the base grille and the floor. 
The gap must be a minimum of 

¹⁄₂" (1.27 cm) in order to add 

the skirt. 
NOTE: If the gap measures less than 

¹⁄₂" (1.27 cm), skip 

steps 3 and 4 of the instructions, and install the base grille 
only.

2. Remove the protective film from the base grille.
3. Snap the skirt onto the base grille. 

4. Trim the skirt by scoring the proper “V” groove with a utility 

knife. Break the skirt at the score line.

¹⁄₄

"

†®TORX is a registered trademark of Textron Innovations Inc.

A

B

A

B

A

B

A