KitchenAid 30" Width True Convection Oven 4 Elements & Warming Element Architect® Series II 尺寸示意图

A

B

D

F

C

F

G

G

H

I

J

K

L

E

KERS205T

Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only.  For complete details, see Installation
Instructions packed with product.  Specifications subject to change without notice.

Electrical: Range must be connected to the
proper electrical voltage and frequency as
specified on the model/serial number rating plate.
The model/serial number rating plate is located
behind the control panel or on the oven frame
behind the storage drawer panel. Refer to the
figures in the “Product Dimensions” section.

This range is manufactured with the neutral
terminal connected to the cabinet. Use a 3-wire,
UL listed, 40- or 50-amp power supply cord
(pigtail). If local codes do not permit ground
through the neutral, use a 4-wire power supply
cord rated at 250 volts, 40 or 50 amps and
investigated for use with ranges.

A time-delay fuse or circuit breaker is
recommended.

The range can be connected directly to the circuit
breaker box (or fused disconnect) through
flexible or nonmetallic sheathed, copper or
aluminum cable.

Ref. W10185365

08-07-08

*Range can be raised approximately 1" (2.5 cm) by adjusting 

the leveling legs.

**When installed in a 24" (61.0 cm) base cabinet with 

25" (63.5 cm) countertop; front of oven door protrudes 2

³⁄₄" 

(7.0 cm) beyond 24" (61.0 cm) base cabinet.

¹⁄₂

⁵⁄₈

⁵⁄₈

⁷⁄₈" (75.9 cm) width

³⁄₄" (67.9 cm) depth to backguard standoffs

A

C*

D

E**

F

B*

Cabinet opening dimensions shown are for 25" (64.0 cm) 
countertop depth, 24" (61.0 cm) base cabinet depth and 
36" (91.4 cm) countertop height.

IMPORTANT: If installing a range hood or microwave hood 
combination above the range, follow the range hood or 
microwave hood combination installation instructions for 
dimensional clearances above the cooktop surface.

NOTE: 24" (61.0 cm) minimum when bottom of wood or metal 
cabinet is protected by not less than 

¹⁄₄" (0.64 cm) flame retardant 

millboard covered with not less than No. 28 MSG sheet steel, 
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 
0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking 
platform and the bottom of an unprotected wood or metal 
cabinet.

¹⁄₄

³⁄₄

¹⁄₂

¹⁄₂

®