KitchenAid 24-Inch 4-Cycle/6-Option Dishwasher, Hard Water Softener, Architect® Series II 数据表
Dishwasher Water Softener Setting
Normal Wash
Button Light
High-Temp Scrub
Button Light
Heat Dry or ProDry
Button Light
1
2
3 (Default)
4
5
6
7
*Average water hardness in the United States corresponds to a dishwasher water hardness setting level of 3, which is the default setting of
your dishwasher.
Filling the Salt Container
IMPORTANT: BEFORE ADDING SALT FOR
THE FIRST TIME, the salt container must
be filled with water to the top of the
opening (approximately 1 qt [0.9 L].)
Water does not have to be added
with subsquent refills.
THE FIRST TIME, the salt container must
be filled with water to the top of the
opening (approximately 1 qt [0.9 L].)
Water does not have to be added
with subsquent refills.
SALT
S
E
L
S
A
L
Z
3. Insert the funnel (provided) into the salt container.
4. Slowly fill the container with the
4. Slowly fill the container with the
dishwasher water softener salt. The
salt container holds approximately
4½ cups (1.0 kg) of salt. As it is
being filled, some water will run
out.
salt container holds approximately
4½ cups (1.0 kg) of salt. As it is
being filled, some water will run
out.
5. Stop filling the salt container when you no longer see that salt
is flowing out of the funnel bottom.
NOTE: You can spoon the salt out of the bag and into the salt
container when it is close to being full to keep any salt from
spilling out into the dishwasher.
NOTE: You can spoon the salt out of the bag and into the salt
container when it is close to being full to keep any salt from
spilling out into the dishwasher.
6. Clean any excess salt from the threads of the salt container
opening.
7. Screw the salt container lid on firmly.
SALT
S
E
L
S
A
L
Z
8. If the dishwasher will not be used immediately, be sure to
wipe out any excess salt that might have been spilled.
Refilling the Salt Container
The dishwasher provides 2 ways to indicate when it is time to
refill the salt container. A typical refill should hold about 4
refill the salt container. A typical refill should hold about 4
¹⁄₂ cups
(1 kg) of salt.
UÊÊ/ iÊViÌiÀÊvÊÌ iÊÃ>ÌÊVÌ>iÀÊ
UÊÊ/ iÊViÌiÀÊvÊÌ iÊÃ>ÌÊVÌ>iÀÊ
cap will turn from green to
clear.
clear.
UÊÊʺ``Ê->Ì»ÊiiVÌÀVÊ
message will appear on the
dishwasher front display
after a wash cycle has
been completed, until the
salt container has been
refilled.
dishwasher front display
after a wash cycle has
been completed, until the
salt container has been
refilled.
SALT
S
E
L
S
A
L
Z
UÊÊÊÌÞ«V>ÊÀiwÊÃV
i`ÕiÊÃÊ>LÕÌÊViÊiÛiÀÞÊÈÊÌÊnÊÜiiÃÊvÊÕÃ}Ê
the factory default dishwasher water hardness setting of 3, but
can vary based on your dishwasher usage and cycle selection.
can vary based on your dishwasher usage and cycle selection.
UÊÊ,i}iiÀ>ÌÊvÊÌ
iÊ7>ÌiÀÊ-vÌiiÀÊ-ÞÃÌiÊ}
ÌÊ>``Ê>Ê
additional 10-15 minutes to the cycle time and 0.6 gal. (2.3 L) to
the water usage. The frequency of the regeneration will depend
on your water hardness level setting.
the water usage. The frequency of the regeneration will depend
on your water hardness level setting.
Additional Information
so
ft
sp
rin
g
TM
©
All rights reserved.
® Registered Trademark/TM Trademark of KitchenAid, U.S.A., KitchenAid Canada licensee in Canada
Printed in U.S.A.
W10321614B
SP W10321615A
SP W10321615A
3/11
2011.
SALT
S
E
L
S
A
L
Z
IMPORTANT:
UÊÊ1ÃiÊÞÊÜ>ÌiÀÊÃvÌiiÀÊÃ>ÌÊëiV>ÞÊvÀÕ>Ìi`ÊvÀÊ
dishwashers. Other salts may contain insoluble additives which
can damage the water softener.
can damage the water softener.
UÊÊ1ÌiÌ>ÊÕÃiÊvÊ`Ã
Ü>Ã
iÀÊ`iÌiÀ}iÌÃÊÀÊ>ÞÊÌ
iÀÊÌÞ«iÃÊ
of chemicals when filling the salt container can damage the
water softener system.
water softener system.
UÊÊ/
iÊÃ>ÌÊVÌ>iÀÊ`ÊÕÃÌÊLiÊwÀÞÊÃiVÕÀi`Ê>vÌiÀÊw}ÊÀÊ
refilling the salt container.
1. Remove the lower rack from the dishwasher
and unscrew the lid to the salt container,
located in the front left corner of the
tub bottom.
located in the front left corner of the
tub bottom.
2. When you are opening the salt
container, some water may run
out. Open the container only to
fill or refill salt.
out. Open the container only to
fill or refill salt.