KitchenAid 30-Inch 4-Burner Dual Fuel Slide In Range, Architect® Series II 安装指南

1. Remove the control knob.

2. Insert a flat-blade screwdriver into adjustment locations 

shown in the following illustration and engage the slotted 
screw. Turn the screw until the flame is the proper size.

3. Replace the control knob.

4. Test the flame by turning the control from “LO” to “HI,” 

checking the flame at each setting.

1. Place your foot against the bottom front of the warming 

drawer, and grasp the control panel and range top with two 
hands as shown.

2. Slowly attempt to tilt the range forward. 

If you encounter immediate resistance, the range foot is 
engaged in the anti-tip bracket.

3. If the rear of the range lifts more than ½" (1.3 cm) off the floor 

without resistance, stop tilting the range and lower it gently 
back to the floor. The range foot is not engaged in the anti-tip 
bracket.

IMPORTANT: If there is a snapping or popping sound when lifting 
the range, the range may not be fully engaged in the bracket. 
Check to see if there are obstructions keeping the range from 
sliding to the wall or keeping the range foot from sliding into the 
bracket. Verify that the bracket is held securely in place by the 
mounting screws.

4. Slide the range forward, and verify that the anti-tip bracket is 

securely attached to the floor or wall.

5. Slide range back so the rear range foot is inserted into the 

slot of the anti-tip bracket.

IMPORTANT: If the back of the range is more than 2" (5.1 cm) 
from the mounting wall, the rear range foot may not engage the 
bracket. Slide the range forward and determine if there is an 
obstruction between the range and the mounting wall. Changes 
to the gas supply must be performed by a qualified service 
technician. If you need assistance or service, refer to the cover or 
the “Warranty” section of the User Instructions, for contact 
information.

6. Repeat steps 1 and 2 to ensure that the range foot is 

engaged in the anti-tip bracket.

If the rear of the range lifts more than ½" (1.3 cm) off the floor 
without resistance, the anti-tip bracket may not be installed 
correctly.

1. Place a rack in oven. 

2. Place level on rack and check levelness of range, first side to 

side; then front to back.

3. If range is not level, pull range forward until rear leveling leg is 

removed from the anti-tip bracket. 

Use

 a wrench or pliers to adjust leveling legs up or down until 

the range is level. Push range back into position. Check that 
rear leveling leg is engaged in the anti-tip bracket.

NOTE: Range must be level for satisfactory baking 
performance.

Replace oven racks in oven cavity. Replace warming drawer or 
storage drawer.

1. Align the drawer glides with the receiving guides.

2. Push drawer in all the way.

3. Gently open and close the drawer to ensure it is seated 

properly on the slides.

A

B