KitchenAid 4.1 cu. ft. True Convection Upper and Lower Ovens Architect® Series 安装指南

Turn power supply

off. Move oven close to
final position. 
•  Remove and discard

shipping materials, tape
and protective film from
the oven. Do Not
remove shipping base
or shipping feet at the front lower corners of
oven.  The shipping feet will protect the lower
oven trim until oven is inserted into cabinet. 

•  Remove and set aside racks and other parts

from inside oven.

Remove trim screws attaching right and

left side trim to oven. Grasp the bottom end of
trim and pull away from oven. Slide top end of
trim downward to remove trim from oven. Take
care not to scratch other surfaces with ends of
trim. Set trim and screws aside on protected
surface.

 A time-delay fuse or circuit breaker is 
recommended.
 Connect directly to the fused disconnect (or 
circuit breaker box) through flexible, armored 
or non-metallic sheathed, copper cable (with 
grounding wire). 
 Flexible armored cable from appliance should 
be connected directly to junction box.
 Fuse both sides of the line. 
 A U.L.-listed conduit connector must be 
provided at the junction box.
 Do Not cut the conduit.
Wire sizes and connections must conform with the
rating of the appliance and to the requirements of
the National Electrical Code, ANSI/NFPA 70 — latest
edition (*, See Page 1) and all local codes and
ordinances.

If the house has aluminum wiring, follow the
procedure below.
a.) Connect the aluminum wiring to the copper

wire using special connectors designed and
Underwriters Laboratories-listed for joining
copper to aluminum. Follow the electrical
connector manufacturer’s recommended
procedure.

b.) Aluminum/copper connection must conform

with local codes and industry-accepted wiring
practice.

Oven must be connected to the proper electrical
voltage and frequency as specified on the
model/serial rating plate. (The model/serial rating
plate is located on the oven door or on the oven
frame.)
 Models rated from 7.3 to 9.6 kW at 240 volts 
(5.5 to 7.2 kW at 208 volts) require a separate 
40-ampere circuit. Models rated at 7.2 kW and 
below at 240 volts (5.4 kW and below at 208 
volts) require a separate 30-ampere circuit.

Completely open oven door. In both back

corners of the door you will see door latches in the
locked position. Rotate both latches forward to the
unlocked position.

Grasp outside edges of door with both hands.

• Begin closing door, at the moment the door

stops closing, lift and pull door toward you.

• Set door aside on a protective surface.