Samsung SNT-1010P 用户手册
8
9
Chapter 1 Preparation
View of SNT-1010
Preparation
To select an IP address allocation method
View of SNT-1010
Front View
Slide the [IP Select Switch ] left or right to position it to <D>or <S>.
D (Dynamic IP) :
Slide the switch to this position for the following cases.
- Select this when you install SNT-1010 on the IP sharer
and use the DHCP function of the sharer to
automatically obtain the IP address.
automatically obtain the IP address.
- When SNT-1010 is installed onto an xDSL
(e.g.VDSL)or Cable modem supporting DHCP.
- When the IP address is automatically allocated by
DHCP without manual allocation.
S (Static IP) :
Slide the switch to this position when you directly enter an
IP address using the IP Installer.
- The factory default setting is Static IP.
- Select this if you are informed of IP address, Gateway and
IP address using the IP Installer.
- The factory default setting is Static IP.
- Select this if you are informed of IP address, Gateway and
Subnet Mask information.
1
Network LED
2
Status LED (
*
)
3
Power LED
4
IP Select Switch
5
Audio IN Port
6
Audio OUT Port
7
Video IN Port
8
Video OUT Port
1 2
3
4
5
6
7
8
Rear View
1
FACTORY RESET Button (
*
)
2
TX Port
3
RX Port
4
Alarm IN Port
5
Alarm OUT Port
6
RS-232C Port
7
Ethernet Port
8
Power Port
1
2 3
4
5
6
7
8
*
Status LED (Indicates the operational status of SNT-1010).
Green
: Normal operation
Blinking Green
: If the IP setting has failed in DHCP
Red
: When the file upload is in process or the NTP connection has failed
Blinking Red
: If SNT-1010 causes a problem or you reset the system to the factory
default, the red LED blinks 3 times.
Blinking Yellow
: When SNT-1010 gets started
*
FACTORY RESET Button : This will return the settings of SNT-1010 to the factory default.
Refer to <Resetting the System> in the user guide.