3M X90 说明手册

34

Command Control via the Network

Command Control via the Network

You can configure and control the projector via the network using RS-232C 

commands.

Communication Port

The following two ports are assigned for the command control.

     TCP #23

     TCP #9715

Command Control Settings

Configure the following items from a web browser when command control is used.

• Command control is not available via communication port (TCP 

#9716) that is used for the e-SHOT transmission function.

NOTE

) Enter 

[https://192.168.1.10] into the address bar of the web browser.

) Enter the Administrator ID and Password and click 

[Logon].

3) Click 

[Port settings] on the main menu.

4)  Click the 

[Enable] check box to open [Network Control Port (Port: 23)] to use 

TCP #23. Click the 

[Enable] check box for the [Authentication] setting when 

authentication is required, otherwise clear the check box.

5)  Click the 

[Enable] check box to open [Network Control Port (Port: 9715)] to 

use TCP #9715. Click the 

[Enable] check box for the [Authentication] setting 

when authentication is required, otherwise clear the check box. 

6) Click the 

[Apply] button to save the settings.

(9)