3M mp8030 用户手册



3M 1996



Multimedia Projector MP8030

Some menu options will have an arrow at the end of the line (VIDEO1, VIDEO2). This arrow indicates that a
sub-menu (Figure 4-4) with additional options will display if you select that option.

VIDEO1

→

SETUP INPUT IMAGE OPT.

RGB1
RGB2

VIDEO2

→

TEST
PATTERN

SYSTEM

AUTO
NTSC
PAL

SECAM

NOTE:
VIDEO1 has an arrow to the
right. If you select this option
the sub-menu SYSTEM will
display. The options are:
AUTO, NTSC, PAL and
SECAM.

PRESS

↓↑

Figure 4-4. Selecting VIDEO1

Press the up/down menu arrow (

↑

↓

) or move the remote control stick switch

(up/down) to highlight

the desired sub-menu option.

To exit a menu and return to the video/RGB image, press

MENU

. You have 10 seconds to make a

menu selection and then the projector will automatically return to the video or RGB image.

4-6. Setup Menu (RGB and Video Picture)

Press the left/right menu arrow (

←

→

) or move the stick switch

left/right to select the SETUP menu.

Depending on the current input source either the RGB menu or Video menu will display.

SETUP INPUT IMAGE OPT.

VOLUME
BRIGHT
CONTRAST
V POSIT
H POSIT
H PHASE
H SIZE

101

800

SETUP INPUT IMAGE OPT.

VOLUME
BRIGHT
CONTRAST
SHARPNESS
COLOR
TINT

RGB Signal Input

VIDEO Signal Input

Select this option:

To adjust the following:

VOLUME

Set speaker/Audio-Out volume (low to high)

BRIGHT

Set picture brightness (dark to bright)

CONTRAST

Set picture contrast (low to high)

SHARPNESS (video only)

Set sharpness of video signal (soft to sharp)

COLOR (video only)

Set amount of picture color (less to more)

TINT (video, except PAL video)

Set video picture tint (red to green)

V.POSIT (RGB only)

Move the picture image up or down

H.POSIT (RGB only)

Move the picture image left or right

H.PHASE (RGB only)

Decrease the picture flicker

H.SIZE (RGB only)

Set size of horizontal picture (narrow or widen)