avolites pearl expert titan 用户手册
Copyright Avolites Limited 2010
Page 100 – 8. Cue Lists
PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00
1> At the top level Program Menu press [Playback Options].
2> Press the blue Swop key for the cue list you wish to edit.
2> Press the blue Swop key for the cue list you wish to edit.
8.7.1
Release mask
[Release Mask] lets you specify using the softkeys which attributes
will be released to their default state when the playback is killed. You
can also use the Attribute Bank buttons on the right side of the
console to set the mask. The default setting is to not release any
attributes.
8.7.2
Fader mode
This option sets how the cue list fader behaves. If set to [Fader Mode
Intensity Kill With Off], the fader masters the overall HTP level and
the cue list remains active (connected) even when the fader is
lowered to zero. If set to [Fader Mode Intensity Kill At 0], the fader
masters the overall HTP level and the cue list is killed when the fader
is lowered to zero. If set to [Manual Crossfader] the fader behaves as
a manual crossfade control, and the cue list will automatically step on
to the next cue when the fader reaches the top or bottom of travel.
8.7.3
Handle Paging
This option allows you to lock the playback on a handle so that it
always appears on that handle no matter what page is selected.
If you select “Transparent Lock” then the playback will appear on the
If you select “Transparent Lock” then the playback will appear on the
current page if no other playback is programmed in that position.
8.7.4
Cue Options
This option allows you to change settings for each cue in the cue list.
To select the cue number to edit, press softkey A then enter the cue
number on the numeric keypad.
•
[Curve] allows you to set a different fade curve for the cue; this
affects how the fade progresses from one cue to the other (for
example you can select a fade which starts off slow, speeds up
in the middle and then slows down at the end). Press H then
select a new curve from the softkeys. The effect of the various
•
[Link] can be set to Press Go, With Previous Cue or After
Previous Cue. See section 8.6.2 on page 96.
•
[Preload] allows you to make this cue load the LTP values from
the next cue within the cue list (for example to pre-position
some fixtures for an effect).
•
[Legend] allows you to set a legend for the cue which is
displayed on the cue list display.
•
[Notes=] lets you enter a note for the cue (“Leaves stage
pursued by bear” or “wake up spot operator”).
8.7.5
Autoload
This option allows you to automatically load a playback with a cue
and is described in section 8.1.3 on page 91.