avolites pearl expert titan 用户手册
Copyright Avolites Limited 2010
8. Cue Lists - Page 93
PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00
by holding down the Avo Shift button and pressing the blue Select
button of the cue list’s handle.
You can change this in the Playback Options to make the cue list
You can change this in the Playback Options to make the cue list
automatically clear when the fader reaches zero (press [Playback
Options] at the program menu, then press the Select button of the
cue list, then select [Fader Mode Intensity Kill At 0].
8.3
Edit
8.3.1
Editing a cue list using Unfold
The Unfold button places each cue of the cue list on one of the
playback faders. This allows you to fire and edit each step individually
as if it was a stand-alone cue.
1> Press the blue Unfold button, then the Select button of the cue
list to be edited.
2> The first 20 cues are loaded into the playback faders. The
display shows the cue numbers and legends.
3> Raise a playback fader to output the contents of that cue (fade
times will operate as programmed).
4> Various Unfold options are available, the details are below.
5> Press Unfold again to get out of unfold mode.
5> Press Unfold again to get out of unfold mode.
•
To edit the contents of a cue: Press Clear to empty the
programmer, raise the fader to output the cue, make the
changes, press A [Record Step], then the Select button for the
cue number.
•
To change the times for the cue, press [Edit Times], then the
Select button for the cue, then set the times (see Timing on the
following page)
•
To Insert a new cue, set up the look for the new cue, press B
[Insert Step], then press the playback button where you want
the new cue to go. All following cues will be shifted on by one
and the new cue will be given a number in between the two
existing cues (for example, if you press playback 3, your new
cue will be 2.5).
•
To Delete a cue, press the blue Delete button then the Select
button for the cue you want to delete. Press the Select button
again to confirm.
•
To change the cue legend, press [Set Step Legend] then the
playback select for the step you want to change.
•
If the cue list has more cues than there are playback faders,
you can swop to the next page using softkeys F and G.
8.3.2
Editing a cue list which is running
You can also edit cues in a cue list while you are running it without
using Unfold.
1> Fire the cue list by raising its fader.
2> Use Wheel A to select the cue number you want to change then
2> Use Wheel A to select the cue number you want to change then
the white
↔
button above the Snap Back button to jump to it.