Samsung bn68-01780j-00 用户手册

■  Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ 

devices only.

■  Connect only one receiver.

■  Check if the Anynet+ device power cord is properly connected.

■  Check the Anynet+ device’s Video/Audio/HDMI 1.3 cable connections.

■  Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.

■  Check whether the TV remote control is in TV mode.

■  Check whether it is Anynet+ exclusive remote control.

■  Anynet+ doesn’t work at a certain condition. (Searching channels, Operating 

WIESLINK Pro, Plug & Play, etc.)

■  When connecting or removing the HDMI 1.3 cable, please make sure to search 

devices again or restart your TV.

■  Check if the Anynet+ Function of Anynet+ device is set on.

■  Check if the Anynet+ device is properly connected to the TV and check if the 

Anynet+ (HDMI-CEC) is set to On in the Anynet+ Setup menu.

■  Press the 

tV button on the TV remote control to switch to TV. Then press the 

tOOLS button to show the Anynet+ menu and select a menu you want.

I want to exit Anynet+. ■  Select View tV in Anynet+ menu. 

■  Press the 

SOURCE button on the TV remote control and select a device other 

than Anynet+ devices.

■  Press any of 

P  /  , PRE-Ch, and such to change to the TV mode. (Note that 

the channel button operates only when a tuner-embedded Anynet+ device is not 

connected.)

■  You cannot use the remote control when you are configuring Anynet+ or 

switching to a view mode.

■  Use the remote control when the Anynet+ setting or switching to view mode is 

complete.

You cannot use the play function when Plug & Play is in progress.

■  Check whether or not the device supports Anynet+ functions. 

■  Check whether or not the HDMI 1.3 cable is properly connected.

■  Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.

■  Search Anynet+ devices again.

■  You can connect an Anynet+ device using the HDMI 1.3 cable only. Some HDMI 

cables may not support Anynet+ functions.

■    If it is terminated by an abnormal situation such as disconnecting the HDMI 1.3 

cable or power cord or a power failure, please repeat the device scan.

Check whether the antenna jack on the recording device is properly connected.

BN68-01780J.indb   67

2008-08-29   �� 11:06:51