buell s1 lightning '97 手册
3-39
INSTALLATION
1.
See
Rotate engine so that both tappets (6),
from the cylinder being serviced, will be installed on the
base circle (lowest position) of the cam.
base circle (lowest position) of the cam.
2.
Apply a liberal amount of engine oil to tappet assembly,
especially the roller needles, to ensure smooth initial
operation.
especially the roller needles, to ensure smooth initial
operation.
3.
Insert tappet (6) into bore in crankcase (1). Rotate tappet
so that flats at upper end of tappet face the front and rear
of the engine. If the tappet is installed incorrectly, pins (2)
cannot be inserted.
so that flats at upper end of tappet face the front and rear
of the engine. If the tappet is installed incorrectly, pins (2)
cannot be inserted.
4.
Insert pins (2) in the holes in crankcase. Place
new
O-
rings (3) over ends of pins. Install plate (4) using screw
(5) with washer (14). Tighten screw (5) to 80-110
(5) with washer (14). Tighten screw (5) to 80-110
in-lbs
(9.0-12.4 Nm).
5.
Slide
new
seal (8) and place retainer (9), over top of
push rod cover (7). Position
new
O-ring (10) at top of
push rod cover. Hold cover at an angle and insert top
through hole in cylinder head. Push up on cover while
aligning bottom of cover with tappet bore in crankcase.
Lower retainer (9) with seal (8) onto crankcase, aligning
locating pin (15) with hole in retainer.
through hole in cylinder head. Push up on cover while
aligning bottom of cover with tappet bore in crankcase.
Lower retainer (9) with seal (8) onto crankcase, aligning
locating pin (15) with hole in retainer.
6.
Insert screw (11) with washer (13) through hole in
retainer (9), and thread into tapped hole in crankcase.
Tighten screw (11) to 15-18 ft-lbs (20-24 Nm).
retainer (9), and thread into tapped hole in crankcase.
Tighten screw (11) to 15-18 ft-lbs (20-24 Nm).
7.
Install rocker covers. See
CYLINDER HEAD, INSTALLA-
TION
starting
on
page 3-20
.
Figure 3-50. Valve Tappet Service
1.
Right
crankcase half
crankcase half
2.
Pin (2)
3.
O-ring (2)
4.
Plate
5.
Screw
6.
Tappet lifter (2)
7.
Push rod cover (2)
8.
Seal (2)
9.
Retainer (2)
10. O-ring (2)
11. Screw (2)
12. Push rod (2)
13. Washer (2)
14. Washer
15. Locating pin (2)
11. Screw (2)
12. Push rod (2)
13. Washer (2)
14. Washer
15. Locating pin (2)
b0134x3x
5
14
4
6
7
1
3
2
9
13
15
11
8
12
10
3