MGE UPS Systems AmpMeter PDU 用户手册

 

 

4. Advanced Operations 

SNMP 

The AmpMeter PDU family of products supports the Simple Network Management Protocol (SNMP).  This 
allows network management systems to use SNMP requests to retrieve information and control power for the 
individual outlets. 

The AmpMeter PDU includes an SNMP v1 agent supporting standard MIB I and MIB II objects. 

NOTE:  For security, SNMP support is disabled by default. 

Set snmp 

Enables or disables SNMP support 

Set snmp getcomm 

Sets the ‘get’ community string 

Set snmp setcomm 

Sets the ‘set’ community string 

Set snmp trapdest1 

Sets a destination IP addresses for traps 

Set snmp trapdest2 

Sets a destination IP addresses for traps 

Set snmp traptime 

Sets the delay for steady state condition traps 

Show snmp 

Displays all SNMP configuration information 

AmpMeter PDU SNMP support must be enabled and configured for access to AmpMeter PDU3 MIB objects 
and generation of all AmpMeter PDU3 traps.   

The AmpMeter PDU SNMP command is used to enable or disable SNMP support. 

At the AmpMeter PDU: prompt, type 

, followed by

 or 

 and press 

. 

NOTE:  A restart of the AmpMeter PDU is required after enabling or disabling SNMP support.  See Performing 
a warm boot on page 28 for more information. 

The Set SNMP Trapdest1 and Trapdest2 commands are used to set the IP addresses of SNMP management 
stations receiving all traps.  AmpMeter PDU supports a maximum of two trap destinations; one must be defined 
to enable trap generation. 

At the AmpMeter PDU: prompt, type 

or

, the Ipaddress and press 

. 

The following sets the trap destination 1 to 64.42.31.208: 

AmpMeter PDU: set snmp trapdest1 64.42.31.208<Enter> 

At the AmpMeter PDU: prompt, type 

or

 and press 

. 

Page 36 - 301-0399-3 Rev B.