Hitachi c1424t 用户手册
PAL-I, PAL-I/I
220-240 V- 50Hz
39W/< 2.5W approx. : C1424R/C1424T
2,5W (at 60% MOD. 10% THD)
3W 8 ohm
10 pages memory FASTEXT (FLOF or TOP) : C1424T
75 ohm unbalanced
PAL I : UHF : channels 21 to 69
PAL I/I : UHF : channels 2 to 12
PAL I/I : UHF : channels 21 to 69
PAL I/I : UHF : channels 2 to 12
PAL I/I : UHF : channels 21 to 69
Frequency Synthesizer Tuning System
34 cm (Diagonal) : C1424R/C1424T
On-Screen Display
100 programmes
21 pin EURO-SCART Jack on back cabinet and
Audio-Video jacks on front cabinet in common connection.
Audio-Video jacks on front cabinet in common connection.
Type R40A01 (requires two 1.5V penlight batteries type AAA size)
366(W) x 339(H) x 376(D)mm : C1424R/C1424T
8.9kg approx. : C1424R/C1424T
TV Standard
Mains Voltage
Power Consumption in normal
Function / Stand-by
Function / Stand-by
Sound Output Power
Speaker
Teletext System
Aerial Impedance
Channel Coverage
Tuning System
Visual Screen Size
Channel indication
Programme Selection
Aux. Terminal
Remote Control Unit
Dimensions (approx.)
Weight
11
Sometimes a performance problem can be easily solved by checking seemingly apparent but often overlooked pos-
sibilities. Checking these points before asking for service could save you time and money.
sibilities. Checking these points before asking for service could save you time and money.
TROUBLESHOOTING
SYMPTOM
No picture and sound
Picture is OK, but no sound
Sound is OK, but no picture
No colour
Excessive noise in picture
Diagonal stripes appear on the picture
Picture has « snow »
Ghost images appear
CHECKPOINT
Check the TV set is plugged in.
Check the Volume, Brightness, and Contrast controls are not set at minimum.
Check the Volume, Brightness, and Contrast controls are not set at minimum.
Check the Volume control is not set at minimum.
Check that the mute function is off.
Check that the mute function is off.
Check the Brightness and Contrast controls are not set at minimum.
Check the Colour control is not set at minimum.
Check the aerial cable is not broken, disconnected or damaged.
The picture may be affected by an interfering signal. (eg. from nearby
amateur radio transmitters or another TV set). The interference can be
reduced to some extent by adjusting the direction or height of the aerial.
amateur radio transmitters or another TV set). The interference can be
reduced to some extent by adjusting the direction or height of the aerial.
Check the aerial cable is not broken, disconnected or damaged. Small dots
all over the screen are caused by a weak aerial signal.
all over the screen are caused by a weak aerial signal.
Check that the aerial direction has not changed after a storm or strong wind
etc...
Ghost images are caused by a signal being reflected from a large building
or a hill : the direction or height of the aerial should be chosen well in order
to minimise the ghosting images.
etc...
Ghost images are caused by a signal being reflected from a large building
or a hill : the direction or height of the aerial should be chosen well in order
to minimise the ghosting images.
SPECIFICATIONS