Keurig B60 用户手册

SECTION 1

Set-Up & First Brew

Ready to Brew Your First Cup

1. LCD Control Center will indicate

“READY TO BREW.”

Place a cup or mug on the Drip Tray Plate.

Lift the Handle and the K-Cup

Pack Holder

will open toward you (fig. 6).

Select a K-Cup

pack.

NOTE: Do not remove the foil
lid or puncture the K-Cup

pack.

Place a K-Cup

pack in the

K-Cup

Pack Holder (fig. 7).

CAUTION: There are two sharp needles that
puncture the K-Cup

pack, one above the

K-Cup

Pack Holder and the other in the bottom

of the K-Cup

Pack Holder. To avoid risk of

injury, do not put your fingers in the K-Cup

Pack Assembly Housing.

Lower the Handle to close the Lid over the
K-Cup

Pack Holder. (When it is closed

completely, the LCD Control Center will
indicate “READY TO BREW” and the Small
Cup, Small Mug and Large Mug Buttons will
flash for up to 60 seconds.)

NOT READY

Setting Up Your Brewer

Unwrap cord and plug the Brewer into
a grounded outlet. Remove all pieces of
packing tape and clear plastic sticker
from LCD Control Center.

Place a large mug (10 oz. minimum) on the

Drip Tray Plate.

Remove the Water Reservoir from Brewer

by first removing Lid from Reservoir (fig. 1),
then lifting Reservoir straight up and away
from Brewer (may be tight), (fig. 2). Rinse
with fresh water.

IMPORTaNT:

You cannot use your Keurig

Brewer until

it has been set-up for its first use as set forth below.

NOTE:

If Brewer has been exposed to temperatures

below freezing, allow Brewer at least two hours to

reach room temperature before brewing. A frozen

or extremely cold Brewer will not operate.

Fill Water Reservoir with bottled or filtered

water so that the water level is just below the
top edge of the Water Reservoir.

Place Water Reservoir base into the left side

of the Brewer and be sure the Water Reservoir
Lock Tabs engage with the Brewer. Replace
Lid on Water Reservoir.

Press the Power Button found directly

above the LCD Control Center (fig. 3).

The LCD Control Center will illuminate and

indicate “NOT READY.” NOTE: A K-Cup

pack

should not be used for this sequence

NOTE: If the Water Reservoir is empty or

not in place on the Brewer, the LCD Control
Center will also indicate “ADD WATER.” None
of the buttons will be activated until water
is added to the Water Reservoir and Water
Reservoir is in place.

Small

Mug

READY

TO BREW

MENU

fig.

Power

ADD

WATER

NOT READY

fig.

Lock Tabs

The Brewer will automatically fill the

internal tank with water and then the water
will be heated. This will take about 4 minutes.
During the heating period, “NOT READY”
(fig. 4) is indicated on the LCD Control
Center. Do not lift Handle during this
heating period.

Once the water is heated, “READY TO BREW”

will be indicated and the Brew Buttons will be
illuminated (fig. 5). NOTE: You may see small

amounts of water coming from the Vent and
dripping into the Water Reservoir during this
and subsequent heating — this is normal.

Lift and lower the Handle. Press the Small

Mug Button to start a cleansing brew. Pour
the hot water into the sink.

10.

The one-time set-up process is now

complete and you are ready to brew!

NOTE: The Brewer may take 15 seconds
between brews and then “READY TO BREW”
will be indicated.

dtp

1005-001900

ctp

dtp

1005-001900

ctp