Bunn FMD-3 用户手册

16

Auger Drive  Motor (Refer to Fig. 2 & 3):

1. Remove all hopper assemblies (20,17) and set

aside for reassembly.

2. Remove the four #8-32 screws securing the hop-

per support plate (19,16), remove plate and set
aside for reassembly.

3. Remove the four #8-32 locking screws, located

inside the dispenser housing on the front of the
auger motor mounting panel (14,11), securing
auger motor mounting bracket (15,12) and auger
motor (16,13) to the rear of the auger motor
mounting panel (14,11).

4. Disconnect the wires from the auger motor (16,13)

to be removed.

5. Remove auger motor mounting bracket (15,12),

auger motor (16,13) and dust seal (17,14) as an
assembly.

6. Remove dust seal (17,14) from auger motor

(16,13).

7. Remove the four #8-32 screws securing the auger

motor to the auger motor mounting bracket.

8. Remove auger motor and discard.
9. Using four #8-32 screw install new auger motor

(16,13) on mounting bracket (15,12).

10. Install dust seal (17,14) on auger motor shaft.
11. Using four #8-32 locking screws install auger

motor, dust seal and mounting bracket to the rear
of the auger motor mounting panel (14,11)

12. Reconnect the wires to the terminals on the auger

motor.

13. Install hopper support plate (19,16) and all hopper

assemblies (20,17).

14. Refer to Fig. 4 when reconnecting wires.

LEFT

CENTER

RIGHT

RED to WHI/RED to
Control Board J3-3

RED to WHI/ORN to
Control Board J3-2

BLK to GRN from
Control Board J3-4

BLK to GRN from
Control Board J3-4

BLK to GRN from
Control Board J3-4

P1639

FIG. 4 AUGER MOTOR TERMINALS

RED toWHI/
BLU to
Control
Board J3-1

29170 080900