Bosch ndn-921 用户手册

106 en | Advanced Mode

FlexiDomeHD 720p IP Camera

AR18-10-B013 | v1.52 | 2011.06

Installation and Operation Manual

Bosch Security Systems

A special IP address (class D address) must be configured for 

multicast operation in a multicast-enabled network. The 

network must support group IP addresses and the Internet 

Group Management Protocol (IGMP V2). The address range is 

from 225.0.0.0 to 239.255.255.255. The multicast address can 

be the same for multiple streams. However, it is then necessary 

to use a different port in each case so that multiple data 

streams are not sent simultaneously using the same port and 

multicast address. The settings must be made individually for 

each stream.

Enable simultaneous data reception on several receivers that 

need to activate the multicast function. To do this, check the 

box and then enter the multicast address.

Enter a valid multicast address to be operated in multicast 

mode (duplication of the data stream in the network). With the 

setting 0.0.0.0 the encoder for the stream operates in multi-

unicast mode (copying of data stream in device). The camera 

supports multi-unicast connections for up to five 

simultaneously-connected receivers.

Duplication of data places a heavy demand on the CPU and can 

lead to impairment of the image quality under certain 

circumstances.

Enter the port address for the stream here.

Click the checkbox to activate multicast streaming mode. An 

activated stream is marked with a check. (Streaming is typically 

not required for standard multicast operation.)

A value can be entered to specify how long the multicast data 

packets are active on the network. If multicast is to be run via a 

router, the value must be greater than 1.