Ferris Industries 5901011 用户手册

Lamp that indicates that the glow plugs are heating.  
Hold the ignition key in the “HEAT” position until 
indicator lamp turns off, then turn the key to start.

Gauge measures the output voltage of the engine 
charging system.

Lamp that indicates a low oil pressure condition.  If 
the indicator lamp is ON, it will turn the PTO OFF.

Gauge measures the engine coolant temperature.  
Lamp  that indicates a high coolant temperature.  If 
the indicator lamp is ON, it will turn the PTO OFF.

The ignition switch starts and stops the engine, it has 
four positions:

 

HEAT 

Heats the glow plugs.

 

OFF 

Stops the engine and shuts 

 

off the electrical system.

 

RUN 

Allows the engine to run and

 

powers the electrical system.

 

START 

Cranks the engine for 

 starting.

Press the mower lift switch to the right (away from the 
operator’s seat) to raise the mower deck it locks into 
the 6” (15,2 cm) position.  Place the adjustment pin 
in the desired cutting height and release the lift lock 
lever.

The PTO switch engages and disengages the mower. 
Pull UP on the switch to engage the mower, and push 
DOWN to disengage the mower.

Moving the throttle control fully forward is FULL 
throttle position.  Always operate the unit at FULL 
throttle when mowing.

The hour meter measures the number of hours the 
PTO has been engaged.  The hour meter has a self 
contained power source so the total hours are always 
visible.

Features & Controls

Displays the fuel level in the tank.

Unit is equipped with a +12VDC, 20A power outlet.

Not 

for  

Reproduction