King Technology prevail feeder (english) 用户手册
• After each testing, adjust the
dial up by 1/2 increment if the
free chlorine reading has dropped
below 1.0 ppm or adjust down
by 1/2 increment if the reading
has risen above 3.0 ppm.
Continue this process each day
until the reading stabilizes between 1.0 and 3.0 ppm.
Start-up and Operation
• Do not add shock in or near the skimmer or into the Cycler
as it could damage equipment, risk potential explosion or
discolor your pool surface.
as it could damage equipment, risk potential explosion or
discolor your pool surface.
• Add a stabilizer or conditioner to
the pool at the beginning of the
season if the stabilizer level is below
20 ppm. This will prevent chlorine
burn off. Follow manufacturer’s
directions carefully.
the pool at the beginning of the
season if the stabilizer level is below
20 ppm. This will prevent chlorine
burn off. Follow manufacturer’s
directions carefully.
• Insert Pac into Cycler.
(Follow directions for
replacing a pac on Page 6.)
(Follow directions for
replacing a pac on Page 6.)
• Replace cap and set the
control dial on the Cycler.
(Follow directions for setting
below.)
control dial on the Cycler.
(Follow directions for setting
below.)
12
Hour Pump Run Time
24
Hour Pump Run Time
PUMP SIZE
PUMP SIZE
1/2 hp
3/4 hp 1 hp 1 1/2 hp 1/2 hp 3/4 hp 1 hp 1 1/2 hp
2.5
2
1
3
1.5
1
1
2
3
2.5
2
3.5
2
1.5
1
2.5
3.5
3
2.5
2
2.5
2
1.5
3
4
3.5
3
2.5
3
2.5
2
1.5
4.5
4
3.5
3
3.5
3
2.5
2
7,000 (18')
9,000 (21')
12,000 (24')
15,000
20,000
Gallons Diameter
POOL SIZE
*
*
*
*
*
*
*
*
T
est Strips
Pool
Strips
Test
and
Spa
1.
2.
3.
4.
5.
6.
7.
Dial settings based on 1.5 ppm.
* – Bypass installation recommended.
* – Bypass installation recommended.
• For the first week test the
pool water daily for free
chlorine to ensure correct dial
setting. Continue to test
weekly throughout the season.
Test strips recommended.
pool water daily for free
chlorine to ensure correct dial
setting. Continue to test
weekly throughout the season.
Test strips recommended.
Remember to adjust dial by 1/2 increments only in order
to prevent over chlorination which may bleach pool
surfaces.
surfaces.
• Shock the pool with chlorine to rid
the water of all contaminants before
beginning
the water of all contaminants before
beginning
.
Follow manufacturer's
directions carefully.
SETTING CONTROL DIAL
• Find your starting dial setting by matching up the
parameters of your pool on the chart.
parameters of your pool on the chart.
RECOMMENDED FLOW RATE 20-60 gpm