Becker 7802 dtm 安装指南
Subject to correction and technical modifications
29
Copyright by Becker GmbH, D-76303 Karlsbad
,QVWDOODWLRQJXLGH
&RQQHFWLQJWKHUHYHUVHVLJQDO
,IWKHVZLWFKRQWKHJHDUER[RUVKLIWOLQNDJHLVDFFHVVLEOH
•
Connect a separate lead to the activated contact.
Connect the lead to socket A pin 2.
/RZOHYHO HDUWKKLJKOHYHO99
Connect the lead to socket A pin 2.
/RZOHYHO HDUWKKLJKOHYHO99
,IWKHVZLWFKLVQRWDFFHVVLEOH
•
Check which lead is routed to the reversing lamp. Then, if neces-
sary, remove the inner cover for the reversing light.
Connect a separate lead to the activated lead of the reversing lamp
and connect to socket A pin 2.
sary, remove the inner cover for the reversing light.
Connect a separate lead to the activated lead of the reversing lamp
and connect to socket A pin 2.
&RQQHFWLQJWKHVSHHGVLJQDO*$/IRUWKHVSHHGRPHWHUVSHHGRPHWHUFDEOH
(OHFWURQLFVSHHGRPHWHU
•
Remove the signal from the speedometer, extend and connect to
socket A pin 1.
socket A pin 1.
)
Depending on the vehicle equipment, the lead for the GAL
signal is usually connected to the DIN - ISO plug of the car
radio. The assignment of the DIN - ISO plug may vary de-
pending on the vehicle type.
signal is usually connected to the DIN - ISO plug of the car
radio. The assignment of the DIN - ISO plug may vary de-
pending on the vehicle type.
•
Minimum requirement for the signal:
+]N+]VTXDUHZDYHVLJQDOQRLQGXFWLYHVHQVRU
+]N+]VTXDUHZDYHVLJQDOQRLQGXFWLYHVHQVRU
/RZOHYHO9KLJKOHYHO99
)
If you do not know the exact installation position / location
of the speed signal, please consult the vehicle manufacturer.
of the speed signal, please consult the vehicle manufacturer.
5HYHUVH
VLJQDO
$
*$/VLJQDO
$