Rockford Fosgate PMX-0 业主指南

4

To mount the unit, you will need to find a flat surface with adequate 
clearance behind that provides enough clearance for the unit and all it’s 
necessary wiring.

1.  Once you have determined a mounting location, you will need to cut 

a circular hole 2” (52mm) in diameter.

2.  After the hole is cut slide the unit and wiring into through the hole.
3.  Take the U bracket and slide over the two studs on the back of the 

unit. Tighten down with supplied nuts.

4.  Press on the trim bezel on the front side of the unit.
5.  Plug in all wiring harnesses and cables. Refer to the wiring diagram 

for wire harness connection types.

SRC

PMX-0

This knob is for adjusting the main volume.

Use these buttons to skip back and forward 
through channels or tracks with a short press. 

Pressing this button will power the unit ON and OFF.

Press this button to play or pause your music. This 
button also acts as a MUTE when the source is in 
AUX mode.

Pressing this button allows you to switch 
between input sources.

Pressing these buttons allow you to adjust the 
subwoofer output UP or DOWN (0-12).

Fig. 1

Pressing this button will allow you to select 
between the two brightness values for the display.

Fig. 2