Dynamic Model Design Limited V003 用户手册

Thanks for your purchase of our new Wireless Telemeter, it’s used in R/C E- powered 

models,eapecaily for Li-poly pack with Align balance connector. It’s will show current power 
pack’s each cells’ voltage on the screen,the max monitor cells is 6. It’s give you a way to got the 
information of your flying/runnig model’ at real time which you don’t known before. 
 

The system include one Tx and one Rx at least. The Tx are in your flying/running model 

and your Rx is with big size screen, which used as a local monitor. Tx and Rx through Binding 
way to know each other and work together. 
      The system worked in 2.4GHz ISM band,and with lower power out. The Tx will scan the 
free channel first when power on. And then worked as normal.the 2.4G wave is not as continous 
as the others’.it’s use work-sleep-work mode. So, the max work together system in one field will 
more than 79 sets. 
 

 
        This system is simple and easy use. It’s designed by skilled enginners and through 
many pilots to take many real flying and checking. It’s totally fix your need in the field. 
 
Step 1: Binding   
            Both Tx and Rx have a Binding push button, before using this stystem, you must make 
the Tx/ Rx know each other first. Rx with inside power pack, you need find another power pack 
which with align balancer connector(it’s a standard connector in current supply Li-poly pack in 
the market),simply,you can use your power pack for Binding process. After you ready for power 
on. Press and Hold the Tx’s Binding Button, and power on. The red LED will flash, that means 
it’s waitting for. You can release the button. Then Press and Hold Binding Button.power on Rx, 
after the first welcome face apeared, release it.The Rx will auto searching the correct Tx. 
a”Binding” word will show on the screen. After Binding sucessed, there will have cell’s volatge 
appeared on the screen.. 
Step 2: system is rady for use after Binding sucessed. You can power off    both and prepare for 
install. 
Step 3: Install your Tx on your plane,you need find a position, that make the antenna out of the 
fuselauge.remeber it’s broad casting transfer mode. 
Step 4: Find a way to install your Rx or hold on your hand. This way is strong and easy see 
when you flying.not influnce your operate and control your RC model. 
Step 5: Rx Setting.   
Step 6: Some thing need pay attention.