R-tron Inc. APEX1933 用户手册
APEX1933 USER
MANUAL V1.2 Tech Support: 1-888-317-8766
4
1.4 Glossary
The following is a list of abbreviations and terms used in this manual.
Abbreviation
Definition
AC
Alternating Current
CDMA
Code Division Multiple Access
DC
Direct Current
DL
Downlink
GUI
Graphic User Interface
LED
Light Emitting Diode
PSU
Power Supply Unit
RF
Radio Frequency
UL
Uplink
VSWR
Voltage Standing Wave Ratio
NCU
Network Control Unit
MCU
Main Control Unit
NMS
Network Management System
SNMP
Simple Network Management Protocol
AGC (Automatic Gain Control)
AGC prevents the equipment from exceeding its maximum output power by reducing the gain
automatically. AGC is used to adjust the gain to an appropriate level for a range of input signal
levels
AGC prevents the equipment from exceeding its maximum output power by reducing the gain
automatically. AGC is used to adjust the gain to an appropriate level for a range of input signal
levels
.
ASD (Automatic Shutdown)
ASD helps protect the amplifier from over load. ASD helps protect the network by preventing
excessive signal output power.
ASD does not:
1. Prevent oscillation
2. Protect from excessive input.
There are three parameters: ASD Level, ASD Time, and ASD Iteration.
If the output power exceeds higher than the “ASD LEVEL”, the equipment will shut down for “ASD
TIME” seconds. If shutdown repeats “Iteration” times, the equipment will require manual re-start.