Redline Communications Inc. AN100UA 用户手册
Red
MAX
™
Base Station
User Manual
Doc. #70-00058-01-01
Proprietary Redline Communications © 2007
July 13, 2007
Page 26 of 117
IF Port (Radio Control)
The terminal has a female N-type port for connection to the modem using a coaxial cable.
This port provides the following functions:
- Local oscillator signal for synchronization between the terminal and radio
- Telemetry signals for control and monitoring the modem
- IF modulated data to/from the radio (wireless interface)
- 24 VDC power to power the radio
This port provides the following functions:
- Local oscillator signal for synchronization between the terminal and radio
- Telemetry signals for control and monitoring the modem
- IF modulated data to/from the radio (wireless interface)
- 24 VDC power to power the radio
Time Synchronization Port
The synchronization interface has two SMA female connectors located on the front panel.
Refer to section 8.6: DC Power Connections on page 109 for additional information.
Refer to section 8.6: DC Power Connections on page 109 for additional information.
Wireless LEDs
Link LED
The wireless Link LED flashes once every 8 frames to provide a 'heartbeat' indicator.
This indicates proper communication with the outdoor unit (ODU), and that the framer is
operating correctly. If this LED is not flashing, there is no possibility of establishing a
wireless link.
This indicates proper communication with the outdoor unit (ODU), and that the framer is
operating correctly. If this LED is not flashing, there is no possibility of establishing a
wireless link.
Table 4: System - Wireless Link LED Indications
LED State
Description
FLASH
Wireless interface enabled and functioning correctly.
OFF
Wireless interface unavailable.
Signal LED
The Signal LED flashes each time a message is received from any subscriber. Message
types include: periodic ranging messages, bandwidth requests, and user data traffic.
types include: periodic ranging messages, bandwidth requests, and user data traffic.
Table 5: System - Wireless Signal LED Indications
LED State
Description
ON
Messages being received from subscribers.
OFF
No wireless link activity.
3.1.4 Ethernet
Section
This section describes the Ethernet LEDs and port connections.
Figure 8: System - Front Panel Ethernet LEDs and RJ-45 Ports
Data Port
The Data port is always enabled. The port can be programmed to operate in full duplex or
half duplex mode and at 10 Mbps or 100 Mbps.
half duplex mode and at 10 Mbps or 100 Mbps.