Redline Communications Inc. AN100UA 用户手册
Red
MAX
™
Base Station
User Manual
Doc. #70-00058-01-01
Proprietary Redline Communications © 2007
July 13, 2007
Page 56 of 119
Add: Click
Add
to save the classifier settings.
Note: Classifier settings are effective immediately when created.
Remove Classifier
Service Flow Identifier: Select an existing classifier to be deleted. The format is:
Service Flow ID. Classifier ID
Delete: Click
Delete
to permanently delete the selected classifier.
View Classifiers
SFID.ClsID: Identifiers for the selected classifier. The format is:
Service Flow ID. Classifier ID
Show: Click
Show
to display the setting for the service flow selected in the Service
Flow Identifier field.
ShowAll: Click
ShowAll: Click
ShowAll
to display settings for all service flows.
HideAll: Click
HideAll
to hide settings for all service flows.
Classifier Table
SFID.ClsID: Identifiers for the selected classifier. The format is:
State: Current state of the service flow:
State: Current state of the service flow:
Active: Classifier is currently active.
Inactive: Classifier is not currently active.
Inactive: Classifier is not currently active.
Prio: Priority setting for this classifier.
DestMac: When displayed, classification is based on this destination MAC address.
DestMac: When displayed, classification is based on this destination MAC address.
Addr: Destination MAC address.
Mask: Destination MAC mask.
Mask: Destination MAC mask.
DestMac: When displayed, classification is based on this source MAC address.
Addr: Source MAC address.
Mask: Source MAC mask.
Mask: Source MAC mask.
Enet Type/Prot: When displayed, classification is based on Ethernet protocol type and
protocol.
UserPri: Matching parameters for the Ethernet IEEE 802.1D user priority value
(Ethernet packets with 802.1Q encapsulation). A packet will match if the priority setting
is equal to, or falls between, the high and low range setting. Valid settings are zero to
seven (0 to 7).
protocol.
UserPri: Matching parameters for the Ethernet IEEE 802.1D user priority value
(Ethernet packets with 802.1Q encapsulation). A packet will match if the priority setting
is equal to, or falls between, the high and low range setting. Valid settings are zero to
seven (0 to 7).
Low: Lowest priority setting of range.
High: Highest priority setting of range.
High: Highest priority setting of range.
VlanID: Ethernet packet 802.1Q VLAN tag. Valid only if Cs Specification is 802.1Q.
Ip Prot.: IPv4 specification. Valid only if the service class Cs Specification is IPv4.
EnetProtocol: When displayed, classification is based on this Ethernet protocol.
Tos: Matching parameters for the IP type of service/DSCP (IETF RFC 2474). An IP type
of service (ToS) packet will match if the "ip-tos" value, after the mask is applied, is equal
to, or falls between, the high and low range setting. Valid settings are 0 to 7.
Ip Prot.: IPv4 specification. Valid only if the service class Cs Specification is IPv4.
EnetProtocol: When displayed, classification is based on this Ethernet protocol.
Tos: Matching parameters for the IP type of service/DSCP (IETF RFC 2474). An IP type
of service (ToS) packet will match if the "ip-tos" value, after the mask is applied, is equal
to, or falls between, the high and low range setting. Valid settings are 0 to 7.