Redline Communications Inc. AN100UXA 用户手册
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 12 of 136
April 19, 2010
1.3
Safety Warnings
1. Read the User Manual and follow all operating and safety instructions.
2. Installation of the antenna and modem must be contracted to a professional installer.
3. This equipments must be installed in compliance with relevant articles in National
Electric Code-NEC (and equiv. Canadian Electrical Code CEC) including chapter 8.
4. The system must be properly grounded to protect against power surges and
accumulated static electricity. It is the user’s responsibility to install this device in
accordance with the local electrical codes: correct installation procedures for
grounding of the modem, mast, lead-in wire and line protection, location of line
protection, size of grounding conductors and connection requirements for grounding
electrodes.
accordance with the local electrical codes: correct installation procedures for
grounding of the modem, mast, lead-in wire and line protection, location of line
protection, size of grounding conductors and connection requirements for grounding
electrodes.
5. The outdoor radio modem units must not be located near power lines or other
electrical power circuits.
6. The indoor unit DC input source must be an isolated secondary DC SELV supply
(60V DC max).
7. The indoor unit is supplied with a grounding power plug. Do not defeat this important
safety feature.
8. The indoor unit power requirements are indicated on the product-marking label. Do
not exceed the described limits and do not overload wall outlets.
9. Position the indoor unit power cord to avoid possible damage.
10. Indoor unit DC power supply connection warning:
DC Power Supply Connections: Warning to Service Personnel
Caution for all
AC and DC models:
AC and DC models:
Double pole/neutral fusing.
Caution for all
DC models:
DC models:
Units are not equipped with power switches and activate
immediately when connected to a power source.
11. IF cable connection caution:
IF Cable Connection: Caution to Service Personnel
Connecting or disconnecting the IF cable connector when the base station is
powered-on may damage the base station equipment.
powered-on may damage the base station equipment.
The base station provides DC power to the outdoor modem through the IF
cable. Installers must ensure that the base station indoor equipment is
completely powered off before connecting or disconnecting the IF cable at the
modem or indoor equipment. Technical service personnel must employ the
same cautions when bench-testing equipment prior to field deployment.
cable. Installers must ensure that the base station indoor equipment is
completely powered off before connecting or disconnecting the IF cable at the
modem or indoor equipment. Technical service personnel must employ the
same cautions when bench-testing equipment prior to field deployment.
12. Do not place the indoor product on or near a direct heat source, and avoid placing
objects on the indoor equipment.
13. Do not operate the indoor device near water or in a wet location.
14. Use only a damp cloth for cleaning the indoor device. Do not use liquid or aerosol
cleaners. Disconnect the power before cleaning.
15. Locate the indoor equipment on a stable horizontal surface or securely mounted in a
19-inch rack.
16. Protect the system by disconnecting the power if it is not used for long periods.
17. Keep all product information for future reference.