Redline Communications Inc. AN100UXA 用户手册
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 39 of 136
April 19, 2010
4.2.2 Status
Click
Status
in the system menu (left side of screen) to view status information about the
wireless interface and Ethernet management interface. Values are updated according to
the screen refresh rate.
the screen refresh rate.
Figure 18: Web: Monitoring - Status - Wireless Status Screen
Wireless Status
CINR [dB]: Mean Carrier/(Interference + Noise) ratio. The CINR value is calculated and
displayed for each automatic screen refresh. The CINR measured by the base station is
based on the signal from the subscriber. Based on this value, the base station may
request that the subscriber change modulation rate.
displayed for each automatic screen refresh. The CINR measured by the base station is
based on the signal from the subscriber. Based on this value, the base station may
request that the subscriber change modulation rate.
Traffic Downlink [kbps]: Rate of traffic transmitted to subscribers.
BW Margin Downlink [kbps]: Downlink bandwidth available that can be scheduled by
the base station, based on the minimum traffic settings for all downlink service flows.
This value is affected by: current downlink modulation for each subscriber, downlink
service flows being added or deleted, and the base station downlink ratio. This value is
available through the Web interface Status page, SNMP, and CLI. If this value becomes
zero, a warning message is entered in the base station log.
the base station, based on the minimum traffic settings for all downlink service flows.
This value is affected by: current downlink modulation for each subscriber, downlink
service flows being added or deleted, and the base station downlink ratio. This value is
available through the Web interface Status page, SNMP, and CLI. If this value becomes
zero, a warning message is entered in the base station log.
CRC Errors: Number of CRC errors detected on packets received from subscribers.
This counter is reset when the base station is rebooted.
This counter is reset when the base station is rebooted.
Note: The CRC Errors counter in the SS Info screen is reset when a subscriber is
registered.
registered.
Air Interface Status: Status of the base station modem:
Enabled - Transceiver is operating normally.
Disabled - Transceiver is disconnected, disabled, or defective.
IDU Temperature [Celsius]: Internal temperature of the indoor terminal.
Power Supply Status: Display the status of the power circuits.